Focused Wind tech II with [9] years of experience in performing repairs and maintenance on turbine components and systems to prevent failures and maximize performance. Specialist in running diagnostic tests, determining causes and solutions for problems and completing repair work. Focused on using technical documentation and instructions to verify proper use of procedures specific to each turbine.
Inspections on Blades internally and outwardly, GWO certified to climb and perform repairs
Installed Lighting Protection System on VESTAS V150 Blades, LOTO certified, Troubleshooting,
Serviced turbines, Lubricate, torque and tension, accumulator swaps and inspections, check Nitrogen levels of accumulators, Accumulator
bracket swaps, Yaw motor swaps,
Inspection of Blades internally and outwardly
Repair damages if any Delamination is found.
Using power tools such as grinder,Handling chemicals properly according to ratio.
Measured and cut angled bars and flat bars of iron using a torch tool.
Operated iron cutting machines
Read structural blueprints, Tack weld
Communication skills, Problem solving,