Christiansen Omar Guerra Boscan

• Pulled EMT and PVC conduit wire according to plans and code requirements.
• Handled installation of electrical components by splicing, joining, and connecting wire.
• Put PVC conduits in underground
• Understood and used proper tools and equipment to install and maintain electrical systems

• Pulled wire through conduits and through holes in walls and floors.
• Complied with safety standards and codes per National Electrical Code.
• Replaced and repaired lighting fixtures and electrical control and distribution equipment.
• Mechanical conduits EMT and PVC

• Installed and wired electrical transformers, service panels, and circuit breakers.
• Planned layout and installation of electrical wiring, equipment, and fixtures based on specifications and applicable code.
• Installed ground leads and connected power cables to equipment.
• Terminations
• Work on any type of voltage following electrical code
• I did underground, I worked on a plate on the roof transmitting the conductors so that they would reach the A/C
• Parking area, fans, exit lanes, corridors, electric rooms

• Accurately read, understood and carried out written instructions.
• Repaired cut cable of various sizes and worked with color-coded wires and cables.
• BASKET TRAY (OFF SET- 90), LEVEL AND INSTALL TRAPICES, WATERFALL BASKET FOR OPTICAL FIBER, LADDER RACK, FIBER RUNNER, CAESER LIFT OPERATOR

Electrical mechanical, both emt and rigid

Working under safety and critical emergency

Placing controls for the union of normal and emergency electricity in order for them to act independently

Putting lights, terminations, pull wires with all labels, Cat5

• Repaired and installed new fixtures, wiring, circuits, and motors.
• Running RIGID PIPE and IMC for motors
• Running Wire on Cable Tray for motors

• I work in Jinko Solar INC for Solar panels.
• Completed rough-in, termination, and underground work.
• Tested electrical systems and components for continuity, current, voltage and resistance.
• Interpreted electrical codes and diagrams to complete electrical repair and installation tasks.
• Operated tools according to prescribed safety practices.
• Run PVC, IMC and EMT Pipes
• Run Wires Any Type
• I do cable tray
• Terminations