Andres Bahamon

-Digging, setting stakes, running PVC pipe, stubbing up and setting underground boxes.

-Laying out rooms mounting 4X4 square boxes, bending and installing EMT Conduit.

-Pulling Jet-line and Wires.

-Installing receptacle's, Switches/Dimmers, Lights and Contactors.

-Wiring Boxes, Panels and Contactor.

-Troubleshooting.

- Digging, setting stakes, running PVC, and RMC.

-Mounting 4x4 square boxes, bending and mounting pipe.

-Pulling Jet-line and Wire.

- Project's started with reviewing the Plans and Materialist going the the storage picking up a wagon with all parts for the project that were present at giving moment.

- Build out all the missing cable ways with either PVC or Aluminum pipe and wiring Ducts depending on customer wish and need of durability (Interior/Exterior).

- Running the Cables for Sensors, Lighting, Pumps fire brigade siren.

-Wiring with heat shrink butt connectors.

- After Programming check vehicles Function's by checklist, clean vehicle out.

- Start preparing components for next Projekt.

- Building industrial control cabinets including 3Phase engine control, Knx Bus systems, Plc and Contactors

-Mounting Cable Conduit System, Outlet boxes before Concrete gets pored.

Working from a ladder and lifts, mounting the cable tray, pulling cables, and installing lights.

- Installing switches, electrical outlets/power outlets (3-phase system).

- Connecting Cables to Panel and Network closet.

- Installing RJ45 Plugs .

- Mounting cable runways.