Brian Bonica

Iupat Dc 711/21

Springfield, NJ

01.2007 - Current

Prepared surfaces for painting by washing, scraping, sanding, and patching holes.
Caulked joints between walls, ceilings, moldings, and woodwork.
Removed old paint layers using chemical strippers or scrapers.
Applied primers and sealers as required.
Utilized ladders and scaffolding to access hard-to-reach areas.
Spray, brush, and roll (9, 14, 18 inch) paint on interior and exterior surfaces.
Cleaned up job sites upon completion of work.
Repaired drywall cracks prior to painting.
Inspected finished surfaces for defects in order to ensure quality standards were met.
Assisted in the installation of trim pieces such as baseboards and crown molding.
Used power mixers and hand tools safely and effectively.
Cleaned and properly stored paint equipment and supplies at end of each workday.
Readied surfaces and surrounding areas for painting with sandpaper, tape and other materials.
Performed repairs to defects in walls by patching holes and scrapes prior at project start.
Applied paints, sealers and solvents to plaster, sheetrock, concrete and wood.
Mixed and applied paints, varnishes and sealants to promote lasting finish.
Operated airless spray equipment, motorized booms, and lifts.
Covered floors before prepping, priming and painting walls and ceilings to protect them from chemicals and paint.
Removed old finishes by stripping, sanding or using water or abrasive blasting.
Removed pictures, door knobs or electric switch covers prior to painting.