Charles Axley

• Installed and maintained electrical systems in compliance with safety standards.
• Collaborated with maintenance teams to optimize equipment performance.
• Performed routine inspections on electrical components to ensure reliability.
• Trained junior electricians on best practices and safety protocols.
• Installed, maintained and repaired electrical wiring, controls and lighting systems.
• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.
• Upgraded outdated wiring systems to enhance performance and reduce potential hazards in the workplace.
• Read the prints to label and wire devices and cabinets.
• Bend and run conduit as needed for the job.
• Wired new VFD drives up to Crane motors and trouble shot during start up.
• As well as any other electrical need AM/C had for us to do.

Managed and maintained accurate time sheets for team members and self.

Bending and running conduit.

Reading prints.

Wiring residential and commercial buildings.

Installing and troubleshooting devices, controllers, and panels for 120/240

/277/480v.

Pulling and making up low voltage HVAC wires, and installing wired and

wireless thermostats and sensors for the Trane Technologies Co.

Ensured compliance with local and national electrical codes.

Collaborated with contractors to plan electrical layouts and installations.

Reference/Owner: Jason Scott (931)320-0949

I was responsible for logging all my maintenance calls and time for each

downtime.

Managed operations involving 120/240 and 240/480 volt systems.

We maintained conveyors, bearings, photo eyes, hydraulics and

pneumatics cylinders, glue guns, elevator systems, and using the PLC's to

trouble shoot during production work.

Conducted regular inspections to ensure equipment compliance with

safety standards.

During non production times we would make repairs and PM the cells to

prevent further downtime.

During shut we would make larger repairs and changes to the lines.

Reference/Leadman: Joel Leterski (931)801-0827

Work with engineers to install robots, controllers, stands and auto debug

the new lines and cells using the HMI.

Maintain the Fanuk robots and cells to prevent further issues.

Make any repairs during or after production as needed.

Wire in new components into the I/O and DNet cards in the Allen Bradley

PLC controllers.

Order and restock and parts needed for the lines.

Put in work orders and time for each day.

Maintaining the lines including but not limited to monitoring photo eyes,

sensors, hydraulic and pneumatic cylinders, turn tables, VFD's, spot weld

robots, and mig weld robots.

Performed routine inspections on machinery and equipment to ensure

optimal operation.

Conducted preventive maintenance on production lines to minimize

downtime and disruptions.

Collaborated with engineering teams on equipment upgrades and

enhancements for efficiency.

Trained new technicians on maintenance protocols and best practices for

safety compliance.

Cleaned work areas to maintain a safe environment free from debris or

hazardous materials.

Reference/Supervisor: Randy Jahn (615)479-9073

Supervised daily operations and staff performance in electrical service

projects.

Coordinated schedules and workflows to optimize team efficiency and

productivity.

Trained new employees on safety protocols and operational procedures

effectively.

Ensured compliance with industry standards during project execution and

inspections.

Assisted in inventory management of electrical supplies and tools for

projects.

Facilitated communication between team members to enhance

collaboration on job sites.

Ensured proper stock levels were maintained throughout the shift.

Addressed any issues or concerns raised by staff during shifts.

Managed daily shift operations, including scheduling and assigning team

members to specific tasks.