Charles Johnson

• Regular PM across numerous facilities at Prudhoe Bay
• Small project new construction
• Regular service calls across the field

Worked briefly on a new construction project in the oil and gas industry. My work consisted of installing cable tray under electrical and high bay building. I also laid out and set switch gear and MCC in Electrical room.

• Worked on North Slope at Milne Point
• Project consisted of installation of separator and two associated mods
• Work consisted of:
• Pulling, strapping, pouring, stuffing, and terminating MC-HL cable.
• Terminating instruments and MOVs
• Installing conduit
• Installing light fixtures, both interior and exterior
• Installing heat trace
• Laying out and installing exterior panels

• Worked fall turnaround at Eastman Chemical
• Installing rigid conduit and associated fittings.
• Pulling wire of all sizes
• Motor cutovers (wired numerous control loops for associated motors.)
• Terminated instruments, motors, MCCs, and control devices
• Pulled cable to, and terminated wire in different rack rooms.
• Use toner, phones, and meter to trace, locate, and utilize existing wiring.
• Wiring of relay panels for deluge system
• Interpreting blue prints

• The 6 months I worked at Alterman were all at a Microsoft data center in San Antonio. I performed a variety of job tasks consisting of:
• Installing cable tray
• Installing conduit
• Pulling cable to, and terminating PDU's
• Terminating busway tap boxes
• Laying out electric rooms and installing equipment
• Acquired Master License while working here

At HSC, I started as a brand new apprentice, and worked into becoming a journeyman, foreman, service electrician, as well as assisting on the take off/bidding, and overseeing of projects. The work consisted of:

• Regular service calls at the North East Babtist Hospital in San Antonio.
• Annual preventative maintenance at the NEB Hospital.
• Many commercial remodels on military bases such as, Lackland AFB, Ft. Sam Houston, Port of San Antonio.
• Lots of motor/lighting control.
• A good bit of 120v to 24v lighting control conversions.
• Lots of light pole work, both new install and troubleshooting issues.
• 6 months industrial work experience at Dyess AFB in Abilene, Texas. Work here consisted of all class 1 div. 1 installs as it was all around jet fuel. Lots of troubleshooting and solving electrical issues around the base. Lots of grounding and cad welding. Some cathodic protection. New light pole install. Emergency fuel shut off controls.
• I did a good bit of control work at an ice manufacturing facility as well as compressor wiring. Worked with equipment tech to commission the system.
• I performed lots of underground work, as both equipments operator and installing conduit/pulling wire.