Colby Eppehimer

At the target Wearhouse I did tasks such as drive forklifts and cherry pickers. Made sure the quata was hit or went beyond the quata. I made sure that the product number was accurate and all accounted for.

• Welded in flat, horizontal, vertical, and overhead positions.
• Inspected welds and checked critical measurements to meet specifications.
• Removed and repaired unacceptable welds with air arc and grinder to meet quality guidelines.
• Chipped off excess weld, slag, and spatter using hand tools.
• Clamped, held, tack-welded, heat-bent and bolted component parts to achieve required configurations and positions.
• Set up and operated shielded metal arc and gas metal arc welding equipment.
• Salvaged and rebuilt parts to achieve cost savings and reduce waste.
• Welded metal components in vertical, overhead and flat positions.
• Cut, grinded and bent edges of materials to be joined for snug fit using power grinders and hand tools.
• Cleaned material surfaces to remove dirt or excess acid using chemical solutions, wire brushes and grinders.
• Used oxyacetylene torch to cut metal and or shapes