Corey Sigman

• Constructed forms for pipe supports, enabling secure installation and alignment of piping systems.
• Operated front-end loader to efficiently load rock trucks with sand and gravel for site preparation.
• Dug pipe ditches for water and gas lines
• Used laser levels
• Set trenwa pieces for underground
• electrical cable with a pipe layer
• Used excavator to install 12” pvc water line
• Follow PnID blue prints to get pipe set up for pressure test.
• Install bolts and gaskets and bolt up and torque flanges
• Coordinated concrete placement in foundation forms, ensuring proper alignment and structural integrity.
• 
  

Run pad operations

• ran the transfer line.

•back in and off load brine trucks into holding tanks

•know when to fire up the transfer line when frack starts to pull water so we can keep up with water in the water tanks

•know when to pump over to the pump down tank for brine

Transferred to rig up in 2020

•fuse poly

• ran the skid steer through woods and hills with spools of lay flat to lay for the transfer line.

•ran excavator to dig road bores for people's driveway.

• redo the heads on lay flat. Also bolted up valves and tees to the suction and discharge hoses to the pump usually 10”.

• Rig up pipe with crane
• Grind and buff welds
• Sandblast and coat pipe
• Jeep the pipe for pin holes or defects
• thread pipe, install fittings
• Bolt up and torque flanges to the well heads to sand trapps
• Bolt up ASD’s to well heads.