Daniel Maldonado

• Leading 20-person crew.
• Reading, using blueprints, a matrix and BIM model.
• Pulling wire through conduit, raceways with wire sizes 14 gauges-600kcmil.
• Bending and installing conduit, 3/4"-4".
• Performed electrical terminations on various systems.

Lighting fixtures, boxes and receptacles.

Distribution, Long board, Branch panels and CTRZs.

VFDs, CMSs, and Pumps.

Assisted and performed live terminations.

• Use of lifts, boom lifts and scaffolding.
• Underground work installing PVC, setting and installing lighting.
• Worked in all levels including SUT, Utility, Sub-fab and Fab.
• Participated in leadership meetings with senior management and intel personnel to align project objectives.

• Pulled and terminated wire across all levels, including 14 gauge to 500 MCM inside distribution panels, branch panels, and D Board, as well as low voltage terminations for reliable electrical connections.
• Interpreted and utilized prints and diagrams for accurate installation and troubleshooting of electrical systems.
• Installing unistrut supports, RMC conduit 1/2" - 4". Installing boxes, floor boxes, twist locks, receptacles.
• Daily use of triple nickel, table bender, hand bender.
• Worked in elevated heights, around nuclear equipment, switches, valves.

• Installed busway systems rated 600V and 1000V.
• Pulled and terminated wire across sizes from 14 gauge to 750 kcmil.
• Assisted and performed in live terminations.
• Mounted Unistrut supports and EMT conduit ranging from 1/2 in. to 4 in., contributing to structural integrity of electrical systems.
• Use of Triple Nickel, table bender and hand benders.
• Use of scissor and boom lift operations for elevated electrical installations.
• Operated in interstitial clean room and sub-fab areas to support electrical installations.
• Read prints and worked from BIM models for electrical layout and installation.

• Pulled 2880 feet of fiber cable, installing raceways and Unistrut supports.
• Terminated fiber cable and connected 14 gauge to #6 wire with lighting fixtures and boxes to complete electrical installations.
• Bent and installed EMT and RMC conduit using hand benders from 1/2 in. to 1 in.
• Installed supports, boxes, light fixtures, switches, and receptacles.
• Read and blueprints to determine electrical layouts and specifications.
• Set up and operated scaffolds, scissor lifts, and boom lifts to facilitate safe work environments.
• Participated in monthly company meetings to stay informed about organizational updates.

• Pulled and terminated wire 8 - 16 gauge, working with live wire, phasing, and numbering circuits for organized and efficient electrical systems.
• Executed installation and maintenance of electrical panels.
• Installing panels, sub panels, 4S/5S boxes, lighting fixtures.
• Installing and terminating power pedestals for EV chargers.
• Installing EMT/RMC conduit 1/2" - 2".
• Installing supports, boxes, light fixtures, switches & receptacles.
• Terminating receptacles, panels in each apartment room, and gear.
• Installing floor boxes, single - 6 gang boxes, light/fan boxes, bathroom fans, washer and dryer receptacles.
• Reading prints, laying out individual rooms with various layouts.
• Led daily discussions with foremen, general foremen, and superintendents to coordinate project progress and address challenges.
• Underground work, installing PVC 1/2" - 3", using excavator, ditch witch.
• Underground work, power jack, pouring and setting concrete.
• Operated scissors and boom lifts regularly to assist with electrical installations.
• Pulling & installing romex wire 10/2, 10/3, 12/2, 12/3, 14/2, 14/3, 1/0 & 3/0.