Daniel Rodriguez

• Read prints pull cables to junction boxes terminate them .
• Run conduit and cable tray .
• Fabricate supports unistruct.

• Installed cable tray , conduit ,channel tray .
• Pulled wire when needed .
• Terminations flex for devices .

*Installed conduit cable tray channel tray fabricated supports for conduit.

• Terminated junction boxes and devices .
• Pulled wire when needed to complete a task

• Installed conduit lights on roof built uninstruct frames.
• Terminated lights terminated junction boxes.
• Installed stands drilled holes in beams for supports set up reciptecales .

• Completed termination, and underground work.
• Installed cable tray conduit and underground duct banks.
• Read technical drawings, diagrams and project documentation to make accurate decisions about electrical system installations and repair work.
• Terminated devices such as Pt’s and Ft’s Junction boxes .

• Used hand and power tools to cut, bend and shape wires.
• Gathered parts, supplies, and tools in preparation for each workday or new job.
• Mounted and installed cables, outlets, switches and other electrical components.
• Cleaned and organized job sites before and after jobs to maintain safety and efficiency of work environment.
• Connected electrical components and equipment.
• Measured, cut and bent Type wire with electrical tools.
• Connected wires to circuit breakers and other electrical components.
• Loaded and unloaded tools, materials and equipment from work trucks and storage containers.

• Pulled wire through conduits and through holes in walls and floors to be near destination in mcc and field side .
• Worked with journeyman to complete task and understand task being performed .
• Organized materials and tools 0peformed housekeeping in and around work area.
• Ran some rigid conduit here and there simple stuff such as 90 degree bends and pulled measurements .