Davonte Mcdaniel

Trench DC , Trench Invertor AC/DC Cable , Erosion Control. Maintenance, Backfill Invertor AC/MV Trench , Backfill DC Trench , Trench Invertor AC/ MV Cable , Pre-Drill, F&I Transformer Gravel Pad , Stage PV Panel , Stage Plies, Stage & Prep PV Rack, Install Load Break Disconnect/Combiner , Install Above Ground DC Cable

string wire termination (combiner box termination)

• string wire ( combiner box testing)

• inverter termination (AC&DC )

•Inverter Testing

•Plug & Play

• Demonstrated expertise in use of cable reels, stripping tools, voltage detectors, and wire and cable cutters to complete fast-paced work.
• Used testing instruments such as ohmmeters, voltmeters, ammeters, and multimeters.
• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.
• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters and oscilloscopes.

Inspecting the field goals,inspecting array fans, checking nuts and bolts after every assignment has been completed, torque nuts and bolts with a digital torque wrench, making sure there was no defects and errors, skid steer operator, staging and distributing materials, and at the end of the site I was doing remediation. Also helping connect converters and pull wires.

• Worked under supervision of journeyman electrician to learn trade and develop electrical knowledge.
• Developed practical skills by actively participating in hands-on training sessions under the guidance of experienced electricians.
• Exceeded expectations for apprenticeship requirements, completing assigned tasks accurately and efficiently under minimal supervision.
• Optimized workspace organization, maintaining a clean and orderly work area that promoted safety and productivity.

Recieving the punch out sheet list so I can walk behind the arrays and check For defects and errors,Flagging bad panels,replacing damaged panels,taking picture of major issues,replacing bad nuts and bolts, replacing missing mob caps, I Was Inspecting three or four arrays a day, and I also trained and relieved workers When Needed Installing Panels

• Evaluated site conditions prior to installation, ensuring optimal placement of solar panels for maximum energy production.
• Mentored junior installers, sharing knowledge of industry best practices and safety standards to ensure consistent quality across the team.
• Demonstrated leadership by proactively identifying areas for improvement in team performance, implementing effective management strategies to address these issues.

Installed Torque Tube , Installed Sleeves, Installed Bearings, Torque Nuts & Bolts , Checked Missing Torque Marks, Installed Modules

• Maintained clean and organized worksites, minimizing hazards and promoting a safe working environment.
• Notified supervisors of defective equipment or material.
• Performed quality checks on products and materials to identify any defects.
• Used variety of hand and power tools to complete tasks.