Eduardo Becerra

• Created and maintained detailed documentation for all processes related to quality control.
• Skilled in CxAlloy, bluebeam, procore, facilitygrid.
• Inspecting instrumentation, plc panels, and control panels are up to project specs
• 
  
• Performed calibration checks on equipment used in the production process to maintain accuracy levels.

Maintain, calibrate, configure, monitor, test, troubleshoot, install, and repair instruments, process controls, data acquisition systems, and electrical system. Complete instrumentation test, wiring, and data acquisition systems. Investigate, diagnose, correct and document instrumentation or system malfunction

Commissioning electrical system’s operating test

Installations of conduit RMC 3/4 to 2 inch cable tray, instruments , pulling wire , operating the green lee 6900 cable puller, leading big wire pulls, installing fixtures flood lights, receptacles, switches , disconnects, panels ,also doing the terminations of devices and instruments working in elevations operating the JLG

• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.
• Interpreted drawings, wiring diagrams, flow charts and written descriptions of project requirements.
• Troubleshot and repaired malfunctioning systems and components.

Installing EMT 1/2 to 4 inch under ground work installing schedule 80 and 40 PVC underground feeders, lightning protection,laying out pipe runs electrical rooms , print reading, installing receptacles ,light fixtures,switches, roughing in walls , installing lighting control devices ,installing branch panels, distribution panels, switch gears , transformers. Trouble shooting testing electrical equipment

• Installed grounding system per NEC code requirements.
• Inspected electrical components to identify hazards, defects, or potential repairs in compliance with codes.
• Supervised apprentices and assessed completed tasks, offering guidance and encouragement.

Installing conduit, cable tray , pull wire ,

• Inspected electrical systems, equipment and components to identify hazards, defects and need for adjustment or repair.
• Examined electrical units for loose connections and broken insulation.
• Troubleshot and repaired malfunctioning systems and components.
• Installed 120/208 volt systems and 347/600 volt systems.
• Repaired and installed new fixtures, wiring, circuits, and motors.
• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters and oscilloscopes.
• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.

Installing EMT 1/2 to 5 inch rough-in walls ceiling, installing switches, receptacles, light fixtures. Pulling wire digging trenches installing panels transformers switch gears installed MC cable terminating panels devices. Trouble shooting reading blue prints for installations

• Performed routine and complex maintenance and repairs on various electrical equipment.
• Followed state and local building regulations based on National Electrical Code.
• Interpreted drawings, wiring diagrams, flow charts and written descriptions of project requirements.
• Planned layout and installation of electrical wiring, equipment, and fixtures based on specifications and applicable code.

Bending EMT, pulling wire ,digging trenches, roughing-in, installing lights, MC cable