Everton Vandunk

● Oversaw the fabrication and installation of boiler insulation.

● Applied block insulation to large pipes, boilers, and machinery, including turbines and generators.

● Installed insulation on hull boards and beam covers.

● Implemented insulation on overhead areas and bulkheads.

● Managed independent installation of large pipe rubber, measuring and cutting precisely for sizes

up to 18-20 inches.

● Independently installed small pipe rubber, ranging from 3/8th inch to 2 inches, with accurate

measurement and cutting.

● Created and implemented flange shields for installation.

● Employed pipe rubber and sheet rubber to insulate pipes effectively.

● Crafted and installed lagging pads as part of fabrication tasks.

● Applied insulation mud and cloth for fiberglass covering on pipes.

● Demonstrated proficiency in handling fiberglass and FSK tape.

● Expertly measured and cut fiberglass pipe covers to fit elbows and straight pipes ranging from 1/2

inch to 12 inches.

● Installed insulation fasteners and studs, including layout planning and installation.

● Utilized various methods such as grinding, shooting, or sticking for fastener installation.

● Prepared materials and workspace before insulation installation, ensuring precise execution and

efficiency.

● Conducted layout planning for stud shooting, shot studs, and installed fire insulation.

Executed fabrication tasks, including measurement, manufacturing, and installation of lagging pads.

● Applied pipe rubber or sheet rubber for pipe insulation.

● Independently installed small pipe rubber jobs, ranging from 3/8th inch to 2 inches, including measurement

and cutting.

● Proficient with fiberglass and FSK tape.

● Measured and cut fiberglass pipe covers to fit elbows and straight pipes, ranging from 1/2 inch to 12 inches.

● Utilized various methods such as grinding, shooting, or sticking for fastener installation.

● Conducted material measurement and space preparation before installing insulation.

● Applied block insulation on large pipes, boilers, and machinery such as turbines and generators.

● Developed layout plans for stud shooting, shot studs, and installed fire insulation.

● Maintained a clear view of and had immediate access to all areas included in the fire watch.

● Effectively communicated with workers exposed to hot work.

● Was authorized to halt work if necessary and restore safe conditions within the hot work area.

● Remained in the hot work area for at least 30 minutes after completion of the hot work, ensuring ongoing

safety unless otherwise determined by the employer or its representative.

● Received training to detect fires in areas exposed to hot work.

● Attempted to extinguish any incipient stage fires within the hot work area using available equipment and

training qualifications.

● Alerted employees of any fire beyond the incipient stage.

● Activated the alarm in case of inability to extinguish fire in areas exposed to hot work.

● Demonstrated physical capability in performing fire watch duties.