FERNANDO CRUZ

Currently working at the new CMC Stell Mill in Mesa AZ . Installing Race Ways, from Underground, to Towers, mostly Rigid Pipe, and Cable Trades, Terminations low and medium voltage, Troubleshooting, and start up systems.

• Observed company safety rules and regulations to minimize workplace accidents and reduce electric shocks.
• Installed and maintained overhead and underground electrical power lines and auxiliary equipment.
• Exercised leadership capabilities by successfully motivating and inspiring others.
• Excellent communication skills, both verbal and written.
• Passionate about learning and committed to continual improvement.

MV Cable Pulling, Preparation, Terminations and Splice 5-35 KV Cold Applied Terminations.

• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters and oscilloscopes.
• Inspected electrical systems, equipment and components to identify hazards, defects and need for adjustment or repair.
• Troubleshot and repaired malfunctioning systems and components.
• Verified problems, investigated faults, and troubleshot solutions to enhance installations.
• Consulted with management on functionality and lifespan of electrical equipment, advising when continued use may be hazardous.
• Tested electrical systems and components for continuity, current, voltage and resistance.
• Adhered to safety protocols, OSHA standards and building codes in installation of systems, operation of equipment, and handling of materials.

Apple Data Center; fire Crew at Night Shift. terminations and wire Pulling, installation of Transformers and Electrical Panels.

• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters and oscilloscopes.
• Installed safety and distribution components for electrical systems, such as switches, resistors and circuit-breaker panels.
• Operated tools according to prescribed safety practices.
• Completed rough-in, termination, and underground work.

Tesla Project worked as a Start-Up at the first section of this Mega Factory, and also as a Supervisor for Quality Plus Services.

• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters and oscilloscopes.
• Followed state and local building regulations based on National Electrical Code.
• Troubleshot and repaired malfunctioning systems and components.
• Tested electrical systems and components for continuity, current, voltage and resistance.
• Adhered to safety protocols, OSHA standards and building codes in installation of systems, operation of equipment, and handling of materials.
• Interpreted blueprints, schematics, and diagrams of project requirements and initiated appropriate electrical installations.

• Identified unsafe or unhealthful workplace conditions or hazards to enforce safe work practices and procedures.
• Conducted routine inspections to check quality and compliance with established specifications.
• At the Nitrogen Facility Port Neal Sergeant Bluff Iowa, in the Instrumentation Department of the Company.

• Conducted regular reviews of operations and identified areas for improvement.
• Identified unsafe or unhealthful workplace conditions or hazards to enforce safe work practices and procedures.
• Maintained compliance with company policies, objectives, and communication goals.
• At Jacobs had the opportunity to get into the Mining Industry, and among with Free Port- Mcmoran as a member of the Start-UP crew, QA/QC, and as a Diagnostic Electrician working with the new systems of Crushers, Ball Mills, Conveyors, with motors from various voltages from 120, 480, 2300 to 4100 Volts.
• Safety Engineering

With Zachry i started my participation in the Solar Industry in the first phase of the Largest Solar Power Plant at the time, 4,000 acres total and the final capacity to produce 700 MW'.

Terminations on Combiner Boxes and Invertors, among with Megging, Hi-Pot Testing, and a Start-Up Crew Members where some of my Responsibilities at this Huge Project.

• Supported company in maintaining work environment focused on quality, communication, collaboration, integration, and teamwork.
• Mentored newly hired employees on operating equipment and safety and developed training manual to use for reference.
• Conducted routine inspections to check quality and compliance with established specifications.
• Final Quality Inspection at one of the Largest Power Plant ( coal ) in the Midwest , Comanche 3 in Pueblo CO as a QA/QC Supervisor.

With D.D.E. i had the opportunity to work on some of the Largest Projects in the State of Arizona. Breaking Ground to Completion of Fab 22 at Intel, the Largest Data Centers at that time Charles Shaw, Children's Hospital of Phoenix, Chandler Mall Center, Mayo Clinic, JW Marriott Resort, Schools and other Industrial Projects, and Data Center Facility for the Nuclear Power Plant Palo Verde.

Started as a Journeyman, Crew Leader and finally a Supervisor with Strong Emphasis in Safety and Quality Control.