Gerardo Canamar Navarro

Duties : Was running emt 3/4 conduit installation , doing 90 degree bends and box offsets.

-Installing electrical boxes as well as running cable threw cable tray.

-Doing electrical terminations into electrical boxes .

-Installing cable tray and basket tray to be able to run high voltage cable.

-Doing field to cut cable tray or basket tray when needed or neccesary according to Foreman.

-Doing cable runs of 500+ feet threw cable tray or basket tray and organizing cable by sequence.

-Able to read and understand electrical installation prints.

-Knowledgeable in operating machinery or any hand power tool.

-Good in team planning and communicating with others.

-Installing headersteal supports or hangers to be able to install aerial cable tray .

-Terminating low voltage and high voltage electrical power into electrical boxes.

Reason of not working here:LAYOFF.

• Terminating low voltage and high voltage electrical power into electrical boxes
• CELLPHONE NUMER 956-562-6210 Working with Kyle Stewart , Alan Oregon, Lucas Palshan, Chesapeake Virginia
• Work Experience Summary; -I have installed IQ conveyor,MDR Conveyor And BSB Conveyor as well ,I have experience installing Sorter Conveyor
• I Have experience installing side guard as well
• I have experience doing RUN-IN ,on IQ Conveyor ,MDR Conveyors BRBConveyor -I Can track IQ belt, and BSB Belt -I have experience doing Lock-Out Tag out when servicing conveyor as well
• I have experience plumbing and leveling conveyor supports or when conveyor is on header steal I can level and plumb conveyor on header steal
• I have experience connecting air hoses to IQ module’s and connecting IQ module wires to photo eyes and aligning photo eye to reflector as well
• I have experience doing conveyor layout, basing off baseline X,Y
• I have experience reading conveyor blueprints
• I have experience installing plows on conveyor
• I have experience installing IQ belt’s and BSB belt’s into the conveyors
• Project’s Worked at
• PROJECT ORF2

• Amazon project Dallas Texas ,Fabricating Headersteal to hang conveyor at exact elevation.
• Running air lines and belts threw conveyor to complete installation and task.
• Runnning electrical wiring on conveyor to complete conveyor functionality.
• cutting and lacing up conveyor belt Cut-To-Fit and then tensioning it to be ableto Run and track it.
• 
  

• Stick and Flux Welding -Demo Work -Using Cutting Torch -Rigging Large Plates For Trinum/Tire
• Working At Heights -Fabricating Supports

• Building Distribution Centers ( UPS,Amazons , FedEx’s) ALL Over U.S
• Millwright /Structural Welder
• Reading Blueprint’s -Welding Conveyor Bed Supports, Header steel,Hangers,C-Channel, Catwalk, Hand Rails, Toe Plate, Grading
• Connecting Beams , Columns -Operating Forklift, Scissor lift, Knuckle Boom -Using Hand and power Tools to Perform Work -Minor RE-Fabricating Work.

• CEMENT PLANT ,DEMO AND REINSTALLATIONS OF CEMENT MILLS AND COAL MILLS IN PUEBLO COLORADO ,GCC PLANT,LONGMONT COLORADO,CEMENT MILLS
• WELDING
• STICK & MIG WELDING
• CUTTING WITH TORCH
• USING HAND & POWER TOOLS
• OPERATING MANLIFT
• DEMOING BEAMS, GRADING ,STAIR WAY ,& CONVEYOR ON THE WAY
• SETTING UP MOTOR TO MILLS.