Gerardo Dorantes

• Pulled 4/10 conductors , 3/10 conductors & cat-6 cables from MCC rooms to various transformers , panels and disconnect boxes.
• Terminated and tested cat-6 in MCC rooms and out on field.
• Installed ground on fence and under gradings and used cat weld to weld the 4/0 ground.
• Installed various disconnect boxes and panels on beams using a boom lift. & tested switch gears with journeyman.
• Installed 1” , 2” & 3” PVC & Ridgid conduit used conduit threader to cut and thread.

• Installed and terminated Cat-6 and fiber cables across various IDF and electrical rooms, ensuring precise connectivity and efficient network infrastructure.
• Installed cameras , WAP’s , Krono’s clocks. Test , label & patched them into IDF’s using a boom lift , scissor lift or ladders.
• Managed to read blueprints & install basket & cable tray as well as various IDG’s in different locations around

job site with little to no supervision.

• Ran 3/4” to 4” conduit using a foot bender ,& one shot.

• Ran Cable Tray & bus ways installed and fabricated supports, ran cable from low voltage to high voltage and 500 and connected it as well to panels and transformers with little to no supervision
• Ran emt conduit from 1" all the way to 4" using foot bender and the one shot, as well as pvc piping

• Would run cable tray and channel tray with journeyman, pull wire (mainly 500) & connect to main panels to branch circuits, use hand tools such as wire strippers, and cutters to prepare the wire for terminations
• Installed emt conduit 1" to 3" with journeyman, as well as replacing light switches, disconnect boxes and fuses as needed

• Company Overview: Working at intel which was a big chip manufacturer company
• Working at intel which was a big chip manufacturer company mostly I would fabricate supports, all thread for cable tray and 1" pipe
• Would use scissor to help the journeyman run pipe and cable down to panel boxes and transformers
• Working at intel which was a big chip manufacturer company

• Company Overview: Electrical contractor working at exxon mobil in Beaumont Tx
• Electrical contractor working at exxon mobil in Beaumont Tx
• Would use hammer drill to make holes and install panels and transformers on to concrete or beams
• Fabricated and installed cable tray, would run mostly 200's and 500's pulls and feed them on to the panels installed and terminated them with the Journeyman
• Electrical contractor working at exxon mobil in Beaumont Tx

• Most of my work on this job consisted of fabricating single strut, and all thread for 32" cable tray would be setting up jacks and pulleys for the spool to run 500 cable