JASON SCOTT
Aurora,CO
Summary
Dynamic Millwright Technician with extensive experience at Welch Equipment, excelling in technical troubleshooting and equipment replacement. Proven ability to diagnose complex electrical issues and perform precise motor installations. Strong problem-solving skills and a commitment to customer service ensure efficient operations and satisfied clients. Adept at collaborating with teams to achieve optimal results.
Overview
7
7
years of professional experience
Work History
MILLWRIGHT TECHNICIAN
Welch Equipment
Commerce City, Colorado
10.2022 - Current
- Extensive experience with tracking and tensioning belts for conveyors as well as replacing drum rollers and regular gravity rollers while also removing lace and replacing it.
- Massive experience working with shrink wrapper machines by diagnosing what’s wrong with them when it comes to electrical problems from shorts and wires to bad fuses to bad PLC‘s. As well as checking and replacing the chain and sprocket that goes under the turntable for the shrink wrapper machine.
- I am able to replace chain all the way up to 120 pitch to as low as 30 pitch.
- I have also had to replace motors that range from up to 15 hp all the way down to 1 hp and have had to replace the reducers that attached to those.
- I am experienced in electrical and motor repairs/ installation for these machines which range up to 10 hp motors.
- Extensive experience working with E stops and can find the issue pretty quick by following the main control panel to figure out where Stop is starting from.
- Able to read blueprints and technical drawings to execute installation projects accurately.
- Experience in collaborating with the PLC specialist that our team hires.
- I am able to operate on some of the new mobile conveyors that an operator can drive forward and backwards. That whole system is run off of one PLC, which I am able to diagnose by tracing bad wire or finding any issue that is causing machine to ground out. I can also assemble these machines together.
- I am on call for seven days in a row once a month for 24 hours per day. I drive around daily to every one of my customers which can be up to 500 miles per day, including to those out of town where I am trusted to diagnose and fix on my own.
HVAC TECHNICIAN
The Premier Group
Denver, CO
07.2021 - 10.2022
- At The Premier Group I installed duct work for commercial buildings, plus demo duct work for prep for the install of new duct work.
- I was knowledgeable at reading blueprints before I started my day to see where I was going to run my duct work.
- I was given a task everyday to run duct in a room or hallway or even to cut dry wall to vent the air outside.
- We also installed exhaust fans for bathroom.
- I took up installing duct to round my general knowledge of HVAC.
HVAC TECHNICIAN
303 Climate Control
Parker, CO
04.2018 - 07.2022
- My duties required me to service roof top units.
- I would service multiple units at a time.
- I would check to make sure the belt for the blower wheel was not too tight or too loose.
- I would replace belts if they needed to be replaced and would check air filters to make sure they were not plugged, which would cause a lack of air flow.
- I would clean the evaporator and condenser coils daily to prevent restriction of air.
- I would check the level of refrigeration with gages to make sure the unit was not over or under charged.
- I can replace a compressor and install a new one, meaning I know the procedure to recover and vacuum and charge the unit to proper level of refrigeration.
- I can trace wire and find dead shorts in electrical when unit is at a ground short.
- I've changed out contractors, relays and capacitors.
- I've been a part of 30 plus brand new roof top installs.
Education
High School Diploma -
Smokey Hill High School
Aurora05-2007
Skills
- Technical Troubleshooting
- Maintenance
- System Installation
- Equipment Replacement
- Problem Resolution
- Customer Service
- Diagnostic Skills
- Parts Knowledge
- Electrical Knowledge
- VFD
- PLC Controls
- Contractors
- Relays
- Conveyor maintenance
- Electrical troubleshooting
- Hydraulic systems
- Motor installation
- Machine diagnostics
- Preventive maintenance
- Customer service
- Team collaboration
- Problem solving
- Welding techniques
- Power tool operation
- Shaft alignment
- Bearing installation
Personal Information
Date of Birth: 04/25/89
References
References available upon request.
Timeline
MILLWRIGHT TECHNICIAN
Welch Equipment
10.2022 - Current
HVAC TECHNICIAN
The Premier Group
07.2021 - 10.2022
HVAC TECHNICIAN
303 Climate Control
04.2018 - 07.2022
High School Diploma -
Smokey Hill High School
Similar Profiles
Troy CarrilloTroy Carrillo
Millwright Technician at Welch EquipmentMillwright Technician at Welch Equipment
Rogelio LopezRogelio Lopez
Parts Coordinator at Welch EquipmentParts Coordinator at Welch Equipment
Martin DobrowolskiMartin Dobrowolski
Field Service Technician Team Lead at Welch EquipmentField Service Technician Team Lead at Welch Equipment
Joshua AlejoJoshua Alejo
Field Technician at Welch EquipmentField Technician at Welch Equipment
Samantha MontoyaSamantha Montoya
Surgical Technologist at UCHealth Highlands Ranch HospitalSurgical Technologist at UCHealth Highlands Ranch Hospital