Jason Steel

FANUC automation cells trouble shooting, Improve robotic paths and optimize speed.

Change weld schedules on bosch welders

Tooling fixtures shim changes

Support process and engineer, Communicate with upper management in process improvement and implement changes.

Welding and Fabrication

Report up to date issues and status

Perform Management Duties

Electrician, Control Voltage, Relay Logic, 480,277,120, and 2300.

Fanuc Robot Programming repairs and service

Heat treat furnace repairs programming and rebuilds

Okuma, Klingenberg, Honda, Gleason bevel gear grinding CNC machines

ASRS Automatic racking system

Siemans and Fanuc Interface

Aisle Taping project planning & Coordinate contractors to perform the task

Train and Carrier Chillers

Cooling towers and water treatment plant daily checks and repairs

Built electrical panels with HMI screens to operate conveyor systems

Maintenance Mechanic, Electrician and Arborist

Rigging and Climbing

Quoted Jobs and Built Customer base

100% Responsible for Customer Satisfaction

Responsible for all Book Keeping Records

Repaired & Documented all equipment

Inspector of Used Parts to determine changes in dimensional requirements,

calipers, micrometers, and other measuring instruments.

Purchased older equipment, replaced and repaired hydraulic system, lights, wiring, and any other mechanic issues.

Executed preventative maintenance procedures for property, plant, and equipment at the hub complex.

Troubleshoot, Repair, Replace and assist with damaged machinery & Allen Bradley Automated Control Systems.

Install and Maintain air, water, hydraulic, and lines for new & current operations.

Proficient in Installation & Repair of electrical systems (480,220,110 and control voltage)

Test device performance

Repaired and maintained, in accordance with diagrams, sketches, operation manuals and manufacturer's specifications.

Installed & Wired electrical box for five stage conveyors

Observed mechanical devices in operation, Trouble shooting problems

Bearing and shaft replacement on bulk rubber mixing machinery

Screw air compressor, hydraulic/pneumatic cylinder and gearbox rebuilds

Electrical and Mechanical Troubleshooting & Repairs on production equipment

Assisted in planning & Implementation of water systems for cooling of the rubber mixing machines.

Repaired & Maintained carriers and Trane chillers and Boiler systems

Installed lighting & Emergency lighting 277v

Replaced motors that tested bad & meagered to insure they were bad 480v