Jose Alberto Esparza Benavidez

Responsible for construction of prototypes circuits boards (PCBA), inspect and rework electronics circuits, operate and set up SMT machines, troubleshoot and perform preventive maintenance of the equipment, develop new processes and procedures to improve the building of circuit boards, make the board assessment to provide feedback to the design team, develop of programs for Screen printer, Solder printer inspection, pick and place machine and develop the oven profile.

Responsible of laboratory to development of cross-section, x-ray, inspection under microscope to find route cause of fails, etc.

Detailed activities:
Screen printer.

PCB Panel array design.
BOM Analysis.

Oven Profile Development.
Stencil Design.

Process Flow.
Program SMT machines.

Wave solder profile.
Fixtures design

Development / Implementation and Improvement in the process of Introduction of new products from front end to back end. Ensure that products comply with manufacturing requirements and quality standards, perform FMEA, process flow chart, Manufacturing Process Instructions, review DFM and help quality team to make the control plan, Performing root cause analysis, using tool as 5 Why’s, Fishbone and other tools.
Detailed activities:
Screen printer.

PCB Panel array design.
BOM Analysis.

Oven Profile Development.
Stencil Design.

Process Flow.
Program SMT machines.

Wave solder profile.
Fixtures design.

Development / Implementation and Improvement in the process of Introduction of new products from front end to back end. Ensure that products comply with manufacturing requirements and quality standards, perform FMEA, process flow chart, Manufacturing Process Instructions, review DFM and help quality team to make the control plan.
Detailed activities:
Screen printer.

PCB Panel array design.
BOM Analysis.

Oven Profile Development.
Stencil Design.

Process Flow.
Program SMT machines.

Wave solder profile.

Development / Implementation and Improvement in the process of SMT. Keeping the products on going with good FPY, low percentage of scrap and reducing line stoppages,
Performing root cause analysis, using tool like 5 Why’s, Fishbone and other tools.
Detailed activities:
Development / Implementation of programs in screen printer, oven profile, works instructions, poka yoke in the process.

Development / Implementation and Improvement in the process of Introduction of new products from front end to back end. Ensure that products comply with manufacturing requirements and quality standards.
Detailed activities:
Laser Etching.

DEK.
SPI.

PCB Panel array design.
BOM Analysis.

Oven Profile Development.
Stencil Design.

Process Flow.
Program SMT machines.

Wave solder profile

Development / Implementation and Improvement in Programs of P&P machines.
Detailed activities:
Program SMT machines.

Generation of load sheets.
Validate System ROMA.

Improve Programs.

Debug technician leader, optimizing staff and supporting production lines to avoid line stoppages due to lack of debugging.
Detailed activities:
Use multimeter.

Use Oscilloscope.

Use Cautin.

Use hot air gun.