Josue Ramirez

• Installed and wired electrical transformers, service panels, and circuit breakers.
• Inspected worksites and installations to verify compliance with state safety codes.
• Used testing instruments such as ohmmeters, voltmeters, ammeters, and multimeters.
• Worked from ladders, scaffolds and lifts to install, maintain, or repair electrical wiring equipment and lighting fixtures in ceilings, on roofs and on towers.
• Planned layout and installation of electrical wiring, equipment, and fixtures based on specifications and applicable code. • Underground PVC pipe installation.
  • Switchgear, transformers and panel installation and connections.
  • Designing a Temporary Power distribution.
  • Underground layout, Decks, electrical rooms, units • TRIMBLE management in all projects.
  • Design and installation of EMT and RIGID pipes.
  • Design and installation of electrical ducts and power wiring, controls and lighting . • Underground PVC connections • Installation of overhead lighting • Pipe cleaning with air compressor • Cable pipe measurement

• Handling of underground machinery
• Wiring of poles
• Handling and connection of PVC pipes
• Work on roofs
• Wiring and connection of low and high voltage panels
• Connection of lamps and motion sensors

●Experience working with threading machine

● Bending of 1⁄2- 1 1⁄4 inch EMT and RIGID pipes

●Bending of tubes with table bender

● Placing ceiling and wall lamps. Placing power points
● Handling of MT pipe 1⁄2 3⁄4 1’ 2’
• EMT and RIGID installation.
• Power Pack installation and connections
• Low and high voltage installation and connections
• Wire pulling
• Dock leveler connections
• Trim and hot check to test the entire circuit panel

● Underground PVC pipe installation.
• Switchgear, transformer and panelboard installation and connections.
• Hoist and crane connections.
• Designing a Temporary Power distribution.
• Underground layout, Decks, electrical rooms, units

• TRIMBLE management in all projects.
• EMT and RIGID pipe design and installation.
• Device and panelboard installation and connections.
• Trim and hot check to test all panel circuits.

• Power distribution

• Cooling tower connections

• Trim and hot check to test all panel circuits.

• Temporary power design and distribution

• Power distribution.
• Device and panelboard installation and connections.
• Design and installation of electrical conduits and power wiring, controls and lighting

• Underground PVC connections

• Installation of overhead lighting

• HILTI laser alignment for the installation of Gripples

• Pipe cleaning with air compressor

• Cable pipe measurement

• Installation, bending and threading in RIGID pipe