JUAN LOPEZ

• Read blueprints or technical diagrams to determine the layout of a system. boxing pulling wire circuits land terminating all the runs on bough sides some remodeling if the wire was damaged or missing
• bending pipe add on to runs that are to short or to close to havc install in wire mold to finish work and going in ever unit and doing a good quality check of ever thing

• Installed electrical wiring and fixtures, such as outlets, switches, circuit breakers, junction boxes and wall sockets. i was a electrical installer doing power distribution centers my job includes running pipe installing gear electrical panels both 120volts and 480 volts
• pulling wire everything from 16 gauge to 700 mcm though cable tray and sporting it with zip tire in a neat and orderly fashion landing terminating all wire
• Measured, cut and bent wire and conduit using hand tools and power tools.

I was a lead person running custom homes doing layout pulling wire boxing running guys panel work reading prints

setting up work for the next day ordering parts for the job teaching guys to do thing on there own so

i can go to different job site doing service calls and remodel work demo work removing oil circuits adding new panels and new pipes new circuits and new receptacles and

T I work remold work in office building did a C.D.O.T well I was working for them

• Connected wires to circuit breakers, transformers or other components.

doing underground work laying out for further locations reading prints box layout pulling circuits making up devices and panel's running pipe building roughing units

doing switch gear landing all the wire in the gear trouble shooting running guys and running crews

• Monitored the performance of apprentices against set targets and objectives.