Kristopher Flores

blankContentIdentifier

• Handled the installation of electrical components by splicing, joining and connecting wire.
  
• Installed 120/208 volt systems and 480/600 volt systems.
• Measured and cut required supplies such as wire and conduit.
• Launched troubleshooting and tests on equipment post-installation to ensure compatibility and safety of electrical systems.
  
• Transported equipment and workers between job sites using company vehicles.
• Configured equipment and optimized performance.
• Checked system adherence to code requirements after performing repairs and maintenance on client systems and equipment.
  
• Actively worked on various industrial projects to repair and maintain electrical systems.
  
• Assessed system adherence to code requirements after handling repair and maintenance work on client systems and equipment.
  
• Placed EMT and Rigid conduits and pulled wire through conduits.
• Spliced, joined and connected wire to junction boxes and other electrical components.
• Utilized equipment for the installation, maintenance and tests of electrical energy systems and components.
  
• Adhered to work site safety protocols and reported potential hazards.
• Evaluated and initiated repair work on various electrical equipment such as light fixtures, controls, switches, relays and circuit breaker panels.
  
• Completed installations and testing for 120/208/240/480/600 volt systems within expected timeframes.
  
• Performed general electromechanical repairs on client systems and equipment, ensuring adherence to code requirements.
• Performed detailed evaluations and made repairs on various electrical equipment such as light fixtures, controls, switches, relays and circuit breakers
• Installed new electrical components, fixtures and motors.
• Repaired existing systems and replaced malfunctioning parts.
• Tested wiring and other system parts for electrical flow and function.
• Followed direction of senior electrical professionals to complete tasks in a safe, accurate and efficient manner.
• Demonstrated knowledge of safety protocols and industry best practices.
• Mastered the use of measuring and testing instruments such as ammeters, ohmmeters, voltmeters and testing lamps.
• Maintained cleanliness and organization of work areas.
• Tested continuity of circuits using test equipment to ensure compatibility and safety of systems following installation, replacement or repair.
• Helped complete system installations, digging trenches and breaking up concrete.
• Configured controllers and set up panels for installations.
• Used hand and power tools and diagnostic equipment to complete various aspects of jobs.
• Worked under supervision of to learn trade and develop electrical knowledge.
• Checked measurements and completed accurate cuts to prevent materials waste and maintain cost controls.
• Worked as an electrical contractor for ConocoPhillips for 4 years

• Maintained orderly and clean work areas for maximum productivity.
• Prepared surfaces for paint application.
• Installed TAC and ASA components.
• Picked up, organized and distributed parts for different work areas.
• Installed and rebuilt packers its components.

• Pressure tested iron
• rebuild manifolds and bonnets
• safety restraints 
• Rig up and Rig down producers