Lawrence Meloro, III

• Perform start-up of new equipment and convert the unit's paramenters to communicate with building automation, such as configuring i-Vu points for every command point to match building automation and checking mechanical functions
• 50AP (50-90 tons) DX machines
• Centrifugal chiller high/low pressure
• Air-cooled chiller
• Multi-stack chiller
• water source heat pump
• Package unit (5-50 tons)
• VAV/PIU box
• Dismantled, adjusted, repaired and reassembled chiller components such as compressors, evaporators, condensers and pumps
• 50AP (50-90 tons) DX machines
• Centrifugal chiller
• Air-cooled chiller
• Multi-stack chiller
• water source heat pump
• Package unit (5-50 tons)
• VAV/PIU box

• Managing contractors and ensuring adequate work was performed
• Troubleshooting and repair of the buildings automations system ALC Webb Controller
• Troubleshoot and repair of chillers, CRAHs, AHU, motor starter cabinets, drive cabinets, pneumatic valves, pumps, cooling towers and other corresponding devices
• Completed maintenance tasks and made adjustments as part of regular upkeep of equipment and safety.
• Broke down complex technical information to the customer in charge of the site in a way that he would fully understand the situation, and reason for spending the money that was needed.

While stationed at Google's data center, I was responsible for monitoring and repairing the mechanical cooling systems, along with the automation which was used to view and control the plant. The skills learned and sharpened are stated below.

• York High Pressure Centrifugal Chiller Trouble Shooting (600-1500 tons)
• Alerton automation hardware/software troubleshooting and install/repair; logic board software download, panel conversions, battery replacement.
• Plate Frame Heat Exchanger
• Cooling Towers
• DX Cooling units ( 90-10 ton units)
• ABB Drive Cabinets
• Munsters units
• Intricate Hydronic Systems, such as multiple basins that works with cold water injection, to even ETP water treatment for blow down water
• Chemical skids that inject Hypo Chlorine in the hydronic system

During my time with Siemens, I worked on an array of different equipment pertaining to our field. Everything form KKT MRI Chillers with European schematics, Low Pressure centrifugals, and even Siemens Apogee. I became comfortable working with automation troubleshooting the front end systems while lending a hand to our controls team members when they were short staffed. Listed below is what I experienced while working at Siemens.

• Low Pressure Trane, York, and some Carrier chillers
• Became certified in Siemens Med KKT Chillers
• DX Cooling systems
• Boilers and correlating hydronic valves for hot water / steam
• VAV & PIU
• Cooling Towers
• Air Cooled Chillers
• Pneumatic Controls
• Siemens Apogee Controls
• Pumps
• Gas Heat

I began my apprenticeship with Lanier Jones and the Journeymen I worked along side with have taught me alot. Listed below is what i had experience in working on during this time.

• DX Cooling
• Ventilation
• Gas Heat
• Air Cooled Chillers
• Low and High pressure chillers
• Boilers
• Hydronics