Lonnie Grigsby

Carpenter/Mason

Pacesetters Personal Inc.

08.2011 - Current

Removed excess mortar and finished joints for uniform surface.
Applied sealants or other protective coatings to waterproof or restore concrete surfaces.
Operated equipment such as forklifts to move bricks and supplies.
Read work orders and design drawings to determine work requirements and sequence of tasks.
Operated drills, paving breakers, and powered abrasive saws to cut or demolish bricks and concrete.
Used straightedges and jointers to mold expansion joints and edges.
Signaled truck drivers to position truck to facilitate pouring concrete into constrained locations.
Installed anchor bolts, steel plates and door sills in freshly poured concrete to provide decorative finish.
Molded expansion joints and edges using correct tools.
Applied hardening and sealing compounds to cure surface of concrete and waterproof or restore surfaces.
Operated power vibrator to compact materials and create level bases.
Prepared surfaces for work by smoothing imperfections on ground or with close structures.
Repaired and replaced damaged bricks, blocks and pavers.
Cut bricks and concrete using approved tools such as powered abrasive saws, paving breakers, drills and hand tools.
Performed basic masonry tasks such as tuckpointing, caulking, grinding and other required duties.
Operated heavy equipment such as forklifts safely and efficiently to move materials.
Measured distance from reference points and marked guidelines to lay out work using plumb bobs and levels.
Identified potential safety hazards and reported incidents and hazards to management.