Martha Aguilera

Assisted in the installation of support cable trays and junction boxes to improve project workflow. Aided in conduit installation for lighting and facilitated cable pulling activities. Performed terminations for 750 kcmil cables with accuracy using hand tools in a data center cleanroom setting.

• Interpreted blueprints,schematics,and diagrams to determine the layout of electrical wiring and equipment for BESS site.
• Installed underground PVC piping for scada racks,FNE,FACP,480V panels.
• Terminations of 480V 270V 220V 120V FNE panels,FACP panels,480V panels,AUX power racks,transformers.
• MV cold shrink terminations 35kv.

• Solar trenching,underground PVC,piping for MV,LV,FNE panels and relay panels.
• Termination of cat6 cable,single pairs,900kcmil cables 1250 kcmil,cable tray install,EMT conduit bend and install,EMT conduit bend and install,panel install.
• Drill holes in panels,grounding,camera install with wiring.
• Lighting install with wiring.
• Lighting panels and terminating.
• AUX POWER RACK install and terminating.
• Terminating transformers and Tesla megapack batteries.

• Worked with a variety of materials including conduit, cable trays, switch boxes and junction boxes.
• Utilized hand tools such as drills, saws, wrenches and pliers for installations.
• Identified potential hazards associated with electrical work areas.
• Performed troubleshooting to identify electrical problems and determine solutions.

• Examine electrical units for loose connections and broken insulation and tighten connections,using hand tools.
• Maintain tools,vehicles,and equipment and keep parts and supplies in order.
• Thread and bend conduit,connect couplings,and fabricate and secure conduit support brackets,using hand tools.
• Perform semi-skilled and unskilled laboring duties related to the installation,maintain and repair of a wide.

• Measure,cut,and bend wire and conduit,using measuring instruments and hand tools.
• Trace out short circuits in wiring,using test meter.
• Drill holes and pull or push wiring through openings using hand and power tools.
• Company overview: Chocolate Bayou

• Put up and bend conduit.
• Put up cable tray,lighting,pull cable to motors and terminating.

• Bend and run conduit,run cable tray,pull cable into tray reading electrical schematics for terminating starter motors,terminate led lighting.
• Pulling wire into MCC building and distributing it throughout the MCC.

• Running conduit on skids Terminating trouble shooting shop maintenance.
• Running and pulling cable on skids wire control.
• Reading electrical schematics for assembly and wiring motor starters for A/C and D/C voltage.
• Replacing fuses for welding machines.
• Terminating motors.