Martin Marez

Baler is a big shredding machine.

I would change the wire spools

Rewire the machine when needed.

Load the bales onto a truck.

Go pick up the waist that I was shredding.

Separate the good from the bad.

Shedding the bad & taking the good to where it could be used.

Would put straps on units

Would have to make sure the strapping pattern was correct or have to change it on the computer.

Same applies to the measurements of the units. Sometimes it was wrong in the computer so it has to be changed in order for the machine to know where to put the straps.

Pull print plates and check them to make sure they have everything they should & make changes as needed.

Pull Dye boards made sure it was the correct board .

Configured printing plates, managed stock supplies, and ensured correct ink alignment.

Make adjustments as needed

Check all measurements and print to make sure everything is correct before running the order.

• Set up and adjusted equipment and properly configured machines for daily operation.
• Complied with company and OSHA safety rules and regulations.
• Loaded raw materials into machines and unloaded finished products to keep manufacturing process running smoothly.
• Streamlined workflow by maintaining a clean and organized workstation, adhering to safety protocols.
• Maintained open communication lines with supervisors regarding project status updates, potential delays, or any concerns affecting production timelines.