NELTON BEKAY

• Followed relevant electrical and building codes for each job.
• Install Emt conduit and rack.
• Install device and termination.
• Underground site and grounding.

• Assemble the solar panel rack.
• Install solar panels, wire, cable tray, and grounding.

Oil and Gas

• Install rigid conduit (underground and above ground).
• Install cable trays.
• Pull wire, labeling, termination, and grounding.

Commercial

• Install Emt conduit, and rack.
• Wire labeling and pulling wires.
• Install devices and termination.
• Grounding

• Install Emt condit and racks.
• Pull wires and labeling.
• Install devices and termination.
• Grounding

• Finished out a solar plant by stringing out wires, connecting wires, dressing up wires, and using zip ties for combiner boxes.

• Install conduit support, ran Emt conduits, Install J-boxes and pull wires.

• Worked on the solar plant connecting solar wires, putting up clips, stringing out wires, installing combiner boxes, grounding, and dressing up wires on solar panels and combiner boxes, using a sun bundler.

• Set up tanks, batteries, layout pipes for trace, oil, water, and vent lines.

• Finished out an oil and gas site by installing conduits, supports, ran rigid conduits, and installed explosion-proof J-Boxes. Pulled wires for transmitters, heat trace, and lighting.