Alfredo Chavez

Identified issues by testing and troubleshooting instruments, components and assemblies using fluke multimeters and other test equipment.

• Inspected equipment to detect electrical leaks and other problems.
• Removed damaged instruments and repaired components.
• Cleaned and adjusted instruments.
• Conducted troubleshooting procedures and root cause analysis to determine causes of problems.
• Conducted preventive maintenance and troubleshooting of metering instruments. such as flow pressure and level transmitters.
• tested thermocouple transmitters for proper working order.
• worked on electrical power plants, turbines, and LNG .
• successfully calibrated different transmitters such as Emerson Rosemount, Yokogawa, Foxboro transmitters (pressure, differential, level transmitters)

• Tested wiring and other system parts for electrical flow and function.
• Installed electrical wiring through conduits and holes in both flooring and walls.
• Obtained measurements and readings using volt and ohm meters, meggers, IC testers, and dial indicators.
• Tested circuit continuity to determine electrical compatibility and component safety.
• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.
• Examined electrical units for loose connections and broken insulation.
• PEEC wiring verified doing point to point

• Cleaned and adjusted instruments.
• Removed damaged instruments and repaired components.
• Conducted troubleshooting procedures and root cause analysis to determine causes of problems.
• Inspected equipment to detect electrical leaks and other problems.
• Identified issues by testing and troubleshooting instruments, components and assemblies using multimeter and other communicators
• Modified, maintained, or repaired electronics equipment or systems to achieve proper functioning.
• Conferred with engineers and designers to investigate and solve failure issues.
• Reviewed existing electrical engineering criteria to identify necessary revisions, deletions or amendments to outdated material.
• calibrations on different transmitters and vales (control valves, open and closed valves fuel gas valves).
• assist in tear down on gas turbines and tested all thermocouples to ensure proper working order.

• Installed, maintained and repaired electrical wiring, controls and lighting systems.
• Connected wires to circuit breakers, transformers, and other components.
• Tested circuit continuity to determine electrical compatibility and component safety.
• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.
• Interpreted drawings, wiring diagrams, flow charts and written descriptions of project requirements.
• Fabricated custom and replacement parts according to specifications, using hand tools.
• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters

• Fabricating and installing conduit and supports. According to drawings.
• assisted in pulling cable for power and instrumentation.
• assisted in DCs upgrade to newer equipment based off of engineering specs
• Troubleshot and repaired malfunctioning systems and components.