Noel Lariosa

1. Pre-Commissioning Preparation 2. Pre-Power Verification 3. Inverter Configuration 4. Energizing and Testing 5. Post-Commissioning Checks

• Site inspection
• Safety checks
• Gather tools
• Documentation
• Insulation resistance test
• Voltage & polarity checks
• Grounding checks
• Inverter setup
• Step-by-step energization
• DC voltage/current verification
• AC output testing
• Performance ratio (PR) testing: Compare actual output to expected;
• Protection system checks
• Grid-support verification
• Monitoring: Test communication with SCADA or monitoring platform

• Identify and remedy defect within the production process.
• Recommend, Implement and monitor preventative and corrective action to ensure that quality assurance standard are achieved.
• Compile and analyze statistical data.

• Cable Termination for all instrument equipment and control panel.
• Ability to understand and read schematic diagram.
• Ability to work safely in unfavorable circumstances.
• Repaired and adjust system component, including removing and replacing defective part.
• Troubleshooting for all instrument devices.
• Performing for final termination to all punch list work.
• Line to line for all electrical and instrument cable.

• Installation of electrical equipment like panel board, transformer and switchgear.
• Wiring and cable termination for all electrical panel board and secondary line.
• Installation of all disconnecting switches, both outdoor and indoor unit.
• Line to line check and megger test activity before the cable termination.
• Commissioning and start up for all electrical equipment both primary line to load side.
• Preparation for inspection and turn over.

• Operational knowledge of digital and analogue equipment.
• Ability to performed electrical & Instrument cable termination.
• Ability to maintain electrical and instrument diagram.
• Ability to follow complicated written and verbal instruction.
• Installation of all instrument control devices.
• Line to line check, cable dressing inside the control panel.
• Troubleshooting to all electrical & instrument devices.
• Final testing and punch list activity.

• Cable dressing, Preparation for cable termination.
• Performed line to line checking from end to end of the cable.
• Performed insulation test of the cable.
• Cable termination, Tightening and final check for inspection.
• Cleaning all over the working areas specially to all electrical equipment.
• Abu Dhabi UAE Tel# (977-6428825)

• Installation of medium and low voltage panel and switchgear.
• Cable preparation for termination from outdoor substation to indoor electrical room.
• Transformer termination from primary line and secondary line side.
• Insulation test for all power cable.
• Final tightening and cleaning.

• Ability to study and review to all electrical plan.
• Performed the electrical lay-out and piping.
• Cable pulling, Panel installation and termination off all cable.
• Installation of back up generator with the ATS panel.
• Installation of all electrical devices like lighting fixture, outlet and switches.
• Installation of internet and telephone cable.
• Testing and commissioning and energize the panel.
• 2/F 368 Tojong St. Camputhaw Cebu City, Philippines

• Ability to performed electrical lay out and wiring.
• Installation of all electrical fixtures and devices.
• Insulation testing, and line to line check every pair of power cable.
• Testing and commissioning.
• Trouble shooting and maintenance.