Pedro Sanchez

Tecogen is a next-generation manufacturer of natural-gas-fueled, engine-driven, combined heat and power (CHP) products that aim to reduce energy costs, reduce greenhouse gas emissions, and alleviate congestion on the national power grid. Tecogen’s environmentally friendly products include cogeneration modules which provide electricity and heat, chillers which provide air-conditioning and optional free hot water and a new ultra-efficient water heater.



performing a diverse set of electric mechanical operations including, compressor and engine installation, customization, building subassemblies, and performing the final assembly of our Chiller and Cogeneration product lines. Reading blue print, crimping ,soldering, use hand tools, Power tools, inverter cabinet, swicht gear, tapping and drilling. Follow diagram .point to point.Wired and assembled coolant pumps, compressors, solenoids, starters, and generators

Performed point-to-point wiring following electrical schematics and blueprints

Wired and assembled electrical control panels

Installed electrical outlets (receptacles) and power connections

Supported troubleshooting and system testing

Used hand tools, power tools, crimping, soldering, and drilling

Installed and assembled SEMiX, SEMIPACK, and power electronic modules

Performed electrical control panel wiring and point-to-point wiring

Followed blueprints, schematics, and work instructions

Performed tapping, drilling, and mechanical assembly

Installed wiring, terminals, and electrical components

Conducted soldering, crimping, and cable assembly

Performed precision assembly including IC placement on PCBs

Maintained ESD-safe handling procedures

* Remodeled Offices and installed furniture

* Responsible for managing building and units

* Duties included operating a variety of hand and power tools, and other equipment such as drills, table saws, chain saws and rotary

* Worked with different systems such as A02, Igto and Vivo

* Mechanical assembly using microscope to inspect job

* Installed cable harnesses and wires

* Read print circuit board

* Followed engineering instruction such as blue prints

• Tested finished products for compliance with tolerances and overall quality
• Removed rough spots to enhance parts alignment and improve finishes
• Made and revised set ups on test strands previously calibrated by other staff
• Analyzed project specifications and other instructions prior to job start to ascertain all tasks and determine completion dates
• Checked position and alignment of each component to prevent errors and minimize materials waste