Phillip Cooper

• Installed plumbing systems and fixtures in residential and commercial properties.
• Followed safety practices and procedures to reduce on-site risks.
• Installed valves, hangers, supports, and flanges inside piping systems.
• Inspected and tested existing plumbing systems for compliance with building codes.
• Selected type and size of piping required for each project.
• Worked from drawings, sketches, or verbal instructions to install and modify plumbing systems.
• Cleaned and maintained plumbing tools and equipment to reduce potential downtime.
• Independently worked on projects, while offering process coordination and cooperation with other teams.
• Operated drill motors, grinders, chop saws, hack saws, and burning torches to perform tasks.
• Measured, threaded, and cut materials to correct angles.
• Cut and drilled holes in walls to permit passage of pipes.
• Used clamps and brackets to attach pipes to walls, structures and fixtures.
• Appropriately fitted pipes by identifying dimensions, sizes, and shapes needed to replace faulty pipes.
• Filled pipe systems with water and air to determine location of leaks.
• Interpreted blueprints to determine locations, quantities, and sizes of materials required.
• experience consists of under plumbing construction experience. using a transit level to determine correct grade for Waste line pvc pipes according to code standards. also operating mini excavators to dig trenches to install sand oil gas interceptors.
• also heavily experienced in general commercial plumbing with the installation of above waste and vent lines . domestic water lines. storm drains, mechanical room installations And setting fixtures such as water fountains , water closet's.
• also expiernced in setting water mains with water meters with back flow systems according to code . and have also brazed copper pipes in under ground systems .
• i have also set drains clean outs sum pumps in under ground systems according to code standards.
• 
  

• Planned layout and installation of electrical wiring, equipment, and fixtures based on specifications and applicable code.
• In my little time in the electrical field i learned numerous electrical systems such as 120/240V systems , 277/480V High Voltage systems . 12 V low voltage power pack systems for the dimming of lights .
• Also very experienced in Fire Alarm systems such as smoke detector systems , Horn expansion Panel systems (horns) (horn strobes) (speaker strobes)
• also experienced in bending conduit using a pipe bender.
• have also trimmed out rooms installing switches outlets and heavy duty outlets for commercial ovens such as 30 amp outlets 3phase
• also experienced in light industrial systems such as mcc rooms (motor control center) installing switch gears and disconnects..

• Operated with safety and skill to avoid accidents and delays.
• Maintained daily, legible DOT log book and submitted corresponding documents.
• Demonstrated safe driving by following regulations and safety procedures, resulting in zero accidents.
• hook up a set of double trailers to a dolly and drive to different locations to meet other drives to swap trailers and drive back to terminal . minimum 500 miles round trip a night

Primary experience is in Metal Stud framing systems with also the instalation of drywall.

Desert Steel Supply was my first job out of highschool and was a metal distribution center i would load up truck with materials such as stainless steel screens schedule 40 pipes square tubing and deliver material to customers.

When work would get slow i would help the main welder grind cut and weld steel tubing to make gates doors balconies and railings . also would help install these structures.