Phillp Taylor

Install wood and lumber processing equipment, update old equipment

Preformed all duties of an electrician on multiple job sites for premier electrical

• Used testing instruments such as ohmmeters, voltmeters, ammeters, and multimeters.
• Demonstrated expertise in use of cable reels, stripping tools, voltage detectors, and wire and cable cutters to complete fast-paced work.
• Worked from ladders, scaffolds and lifts to install, maintain, or repair electrical wiring equipment and lighting fixtures in ceilings, on roofs and on towers.
• Installed, maintained, repaired, and tested equipment for electricity generation and utilization.
• Stored and maintained power tools and equipment for each job.
• Planned layout and installation of electrical wiring, equipment, and fixtures based on specifications and applicable code.
• Inspected electrical systems, equipment and components to identify hazards, defects, and repair requirements.
• Coordinated with other trades and general contractors to facilitate layout of recessed fixtures and architectural lighting.
• Read and interpreted electrical, mechanical, and architectural drawings and electrical code specifications for wiring layouts.
• Enhanced quality control by inspecting condition of equipment and tools.
• Inspected worksites and installations to verify compliance with state safety codes.
• Performed routine and complex maintenance and repairs on various electrical equipment.
• Installed and wired electrical transformers, service panels, and circuit breakers.
• Tested continuity of circuits in electrical wiring, equipment and fixtures using oscilloscopes.
• Interpreted drawings, wiring diagrams, flow charts and written descriptions of project requirements.
• Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.
• Tested electrical systems functionality and continuity of circuits using devices such as ohmmeters, voltmeters and oscilloscopes.
• Studied building schematics to determine location of wiring and equipment.
• Installed 120/208 volt systems and 347/600 volt systems.
• Inspected electrical systems, equipment and components to identify hazards, defects and need for adjustment or repair.
• Fabricated custom and replacement parts according to specifications, using hand tools.
• Followed state and local building regulations based on National Electrical Code.