Ramon Soltero

-Terminate wires in panels and motors

-Run conduit

-Install lighting fixtures, receptacles and panels

-Read and interpreted electrical, mechanical, and architectural drawings and electrical code specifications for wiring layouts.

-Set christy boxes

-Pull wires

-Repaired or replaced wiring, equipment and fixtures using hand tools and power tools.

-Worked from ladders and lifts to install, maintain, or repair electrical wiring equipment and lighting fixtures in ceilings, on roofs.

-Foreman

-Build panels for customers

-Read panel prints

-Communicate with customers and vendors

-Perform and install to NEC standards

-Troubleshoot and do service calls

-Use power tools and lifts

-Read blueprints

-Run conduit

-Pull wire/cable

-Coordinate with other contractors and customers

-Test and ensure electrical equipment after installation

-Installed and wired electrical transformers, panels, and circuit breakers.

-Pulling wire or cable.

-Running pipe (Emt, Rigid, Stainless, O-Cal, PVC)

-Bending pipe. (offsets, saddles, kicks, 90s)

-Terminating wires in MCC's

-Wiring up lights, receptacles, motors, disconnects, control boxes and start-stop buttons.

-Running jobs with small crews (2-5 guys)

-Basic knowledge of CAT 6

-Able to read blueprints

-Setting christy boxes, panels and transformers

-Setting up wire pulls

-Able to use hand and power tools

-Able to drive boom lift, grade all, scissor lift, forklift

-Installed and wired electrical transformers, panels, and circuit breakers.