Raymundo Torres-Navarro

AIT 15T March 2023 To May 2023

• Followed safety procedures while analyzing issues and working on aircraft.
• Recorded maintenance actions in aircraft logbooks.
• Performed work in adherence with aviation regulations and protocols.
• Assisted with aircraft and equipment transport and movement.
• Removed and installed aircraft subsystem component assemblies such as engine starters, fuel pump, greasing main and tail wheel bearings, and FAT gauges.
• Performed inspection on FAT gauges. Removed both. Separated and labeled both. Placed thermometer in ice water and waited for a stable temperature and did the same with room temperature water. Placed gauges into the same water, at separate times and waited for stable temperature. Gauges must read, within tolerance, 2 degrees at both test points for the ice water and room temperature water.

• Worked on both home and business units for maintenance and small repairs.
• Used large equipment, such as compressors, vacuums and ladders.
• Drive to multiple locations.
• Talk to each customer, explain the work I'll be doing and possibly additional work needing to be done.
• Disassemble, repair and reassemble dryer
• Troubleshoot dryer or dryer vent
• Inspection on chimney

• Demonstrated close attention to detail to verify quality and accuracy of work.
• Followed established job site safety regulations and maintained safe and clean work area.
• Planned and executed work with proper tools and materials to maximize productivity.
• Read and interpreted blueprints to follow specifications of projects.
• Checked measurements and completed accurate cuts to prevent materials waste and maintain cost controls.
• Discarded debris and disposed waste to maintain cleanliness and quality standards.
• Shaped or cut materials to specified measurements using hand tools, machines and power saws.
• Effectively used nails, screws, pneumatic nailing systems, concrete anchors, powder-actuated fasteners and framing connectors.

• Installed hardwood, laminate and vinyl flooring for multiple residential and commercial clients.
• Swept, scraped, and chipped dirt and irregularities from base surfaces and filled cracks with cement and putty to form smooth foundation.
• Maintained excellent communication, cleanliness, and safety standards on work sites and projects, boosting customer satisfaction ratings
• Cut and trimmed flooring to fit around obstacles and within tight spaces.
• Conducted accurate measurements and calculations to verify proper layout and installation.
• Applied adhesive substances to properly secure flooring and support longevity.
• Spread adhesive cement over floor to prevent board joint wearing.