Ricardo Hale

Worked at an NSC site building 20 motor control centers. At these control centers I ran conduit, cable tray,and pulled cable. Terminated switch gear, motor controls, transformers, power supplies, and enclosure cabinet. Also ran the fire alarm and terminated the HVAC systems.

• Followed safety protocols and guidelines during all electrical installations.
• Utilized hand and power tools for efficient installation tasks.
• Supported senior electricians with troubleshooting and repair activities.
• Installed conduit, wire and motor controls.
• Ensured that all work was completed in accordance with applicable codes.

• Built skids for different fracs for various locations
• Ran rigid conduit
• Terminated j boxes, motors, and start stop switches
• Built racks for electrical equipment
• Terminated temperature translators and flow transmitter
• 
  

• Installed wireways, ran conduit and cable tray, ran ground bus for structural grounding, installed in terminated switch gears transformers backup power supplies analog systems etc, worked with rigid conduit, terminated stress Cones, did some glanding, worked on motor control centers and also built skids for turbo Fab for overseas work
• 
  
• Used hand tools such as drills, saws, wire strippers, and crimpers to complete tasks.
• Installed conduit systems, various lighting systems, and basic control systems.
• Corrected issues and installed new fixtures, wiring, circuits and motors.
• Installed motor feeders and made standard motor connections.
• Connected wires to circuit breakers, transformers or other components to form circuits.
• Kept work areas clean, neat, and free of hazards.
• Tested continuity of circuits using testing devices such as ohmmeters, voltmeters, ammeters.
• Conducted tests on electrical components, circuits, and systems to ensure compliance with safety standards.
• Verified measurements and made accurate cuts to avoid wasting materials on job sites.

• Ran cable tray and rigid conduit for tank farm
• Pulled wire to different tank locations
• Installed lighting around tank farm, and junction points
• Terminated motors, Saubs, hubs, level switches, controls, transformers and switch gears,
• Did all the heat tracing

• Upgraded service
• Ran conduit to various locations along with cable tray
• Pulled cables from point to point and did Loop checks while meging out cables
• Terminated switch gear, motors, transformers, lighting, etc.
• Shut down and startup