Rigoberto Martinez

Conduit (EMT, rigid, PVC)

underground

Plastic Bond conduit.

Channel tray, cable tray, ladder tray.

Installation supports.

Low voltage terminations.

High-voltage terminations.

Stress cones fabrication and terminations.

Fabrication and installation of cable tray, channel tray, and ladder tray bending and fittings.

MCC installations from VFDs to switchgears and panels.

Cable pulling and terminations in MCCs, low and high voltage wire.

Communication wire pulls

Conduit (EMT, RIGID, PVC) installation and fabrication, with supports.

Used hand tools and power tools, such as drills, saws, wire strippers, and crimpers, to complete tasks. Torquing.

Addressed and resolved worksite safety hazards to reduce risk.

Performed rough-in, termination, and underground work.

Stress cones fabrication and terminations.

Plastic bond conduit.

Low & High voltage terms.

• Installed cable trays from 9” to 42” with supports.
• Built MCCs according to blueprints and layouts.
• Installed 3/4” to 6” rigid conduit, with associated supports.
• Grounding and bonding.
• Worked on duct banks, installed PVC, EMT and RIGID conduit, and supports.
• Low & High voltage terminations.
• stress cones fab and terms
• plastic bond conduit
• underground work

• Temporary power installation
• EMT conduit rack building
• OSR fire alarm installation
• Switches, resistors, and circuit-breaker panels were among the safety and distribution components I installed for electrical systems
• Fixtures, wiring, circuits, and motors were repaired and replaced
• Used tools in accordance with established safety procedures
• 3/4"-2" conduit installation
• Electrical panel installation and termination
• Light hanging and connection

• Reloc runs for lighting connections
• Associated support assembly and figuring
• Electrical panel assembly
• Wire pulls for switch gears, transformers, and panels
• Installations such as fire alarms and lighting
• Terminations on electrical panels for conveyers
• Installation of pipe rack
• Conduit bending1/2"-4" with foot, electric, and hydraulic benders
• Tie-ins and terminations
• Mastered the use of measuring and testing
• Always kept a clean work area with only necessary tools to complete task
• Conduit threading
• Examined electrical systems, equipment, and components for hazards, defects, and repair needs

• Followed standards and procedures to keep a safe working environment
• Used various types of splices, connectors, and clamps to add or remove wire to shorten or lengthen lines
• Worked on both energized and dead lines
• Conduit threading
• Pipe racks and runs
• Conduit bending
• Electrical troubleshooting
• Electrical installations, such as lighting fire alarm and smoke detectors

• Installed and connected electrical wiring equipment and lighting fixtures using ladders, scaffolds, and lifts
• Installation of1/2"-4" EMT conduit
• Light hanging and connection
• Junction box, transformers, electrical panels installation and connection
• Used ohmmeters, voltmeters, ammeters, and multimeters as testing instruments
• Circuit breakers, controls, fuses, lights, and motors were all installed, tested, and modified by me
• Tested electrical systems and circuit continuity in electrical wiring, equipment, and fixtures using various testing devices