Rita Vacek

• Conduced crucible testing on new designs for release
• Conducted failure analyze on RA
• Set up and programmed PLC for monitoring testing
• Helped with some PBC board assembly repair.
• Used lab chambers for various types of testing

• built more complicated electronic assemblys
• Potted up completed modules
• Programmed and tested Electronics before shipping
• Used shop drill press and band saw when needed.

• Performed acceptance testing and measurements on electronic components and assemblies to verify system compliance.
• Contributed to the continuous improvement of company procedures through constructive feedback and suggestions.
• Ensured consistent quality control by conducting thorough inspections of completed work.
• Increased workplace safety through proactive identification of potential hazards associated with electronic equipment operations.
• Facilitated knowledge sharing by documenting failures and nonconforming product.
• Troubleshoot and repairing units as needed or time allowed
• Conferred with engineers and designers to investigate and solve failure issues.
• Conduct ESD Training
• Conduct Solder training
• Conduct internal Audits and S6 Audits
• Conduct ESD maintenance / cal
• Incoming board inspection when time allows

• Did cross training

- Injection molding (Main)

- Compression molding

- Injection molding

- Milling (mixing)

- Compounding

- QC