Ronnie Battle

Load up logs on to the belt , pack meat products in bag , operate the machine slicer

• Grabbing birds off the line and using the knives your equipped with to cut off the bad meat on the bird and put it back on the line repeatedly until next break
• Next station I would hang birds and make sure they are not getting stuck jamming the line up and clean and spray area that im currently in until its clock out time

• Grab my tool bag and a company truck and go to the office to see where I'm assigned to go to for today, then we would go to the house we are assigned to work on
• I would fix duck work under the house that need replaced or fixed
• Also duck work in the attic and installing air and heat units outside of each home
• Last I would install the thermostat inside the house and check with the owner and make sure the customer is satisfied and go back to the company site at the end of the day and clock out

• I would grab a square piece of medal (it takes 2 people) and would set it on the metal bending machine and set the machine so it can bend the medal the right degrees
• After bending the medal I would take it to the next machine and put holes in it if needed and fill corners up with Styrofoam repeatedly through the day
• At the end of the day clean up my area, write down everything I done and turn it in and clock out

• Putting parts on forklift (i was installing wires sometimes and using wrenches to tighten up bolts and other hand tools to put on a part that it needs) and every part I put on I would have to put it in the computer to make sure what I done was correct and send it down the line (at the time I was working 2 spots)
• So the next station I would zip tie a forklift book that teaches you about the forklift and basically check behind everybody that put a part on the forklift to make sure it's correct
• After I check everything off I would push the forklift in the right spot so it can be picked up

• First in the morning grab a walking pallet jack and unload the truck
• I would start feeding the cutting machine right after to cut the boxes in half and when finished cutting all the boxes I would put them in the right place for the pickers on the assembly line
• Then I would help on the assembly picking items and sending them to shipping and receiving
• Sometimes I would go grab a scanner and riding lift to pick orders as well

• I would dig deeper ditches to lay pipes and ground wire using shovels and team work to complete task and also install solar panels most of the time