Ryan Stewart

• Determined layouts to install wiring in automated systems based on drawings and code specifications.
• Setup and program devices to control well pads, gas compressors, and variable frequency drives
• Be an on call tech for service calls and help to maintain a high run percentage for a oil and gas field, from compression and midstream to down hole and well production.
• Troubleshoot devices including rosemont transmitters, Murphy controllers, Altronic controllers, Roc flow computers, Redlion protocol convertors and Allen Bradley components.

• Supervised, trained and evaluated electrical apprentices
• Supervised electrical operations in the construction of compressor stations, well locations and industrial facility upgrades.
• Build primary powerline into facilities over head and underground. Make up the high voltage terminations in transformers and switchgear.
• Estimated dollars and materials for department work orders.
• Troubleshoot and maintain electrical in gas plants, compressor stations, well locations and industrial manufacturing. Including troubleshooting and changing of motors, relays, bad wires and PLC card and components.

• Handled installations of electrical devices
• Repaired electrical circuits, including lighting, general use receptacles, dedicated device circuits.
• Pulled wire, ran conduit, and mounted panels
• Helped with the installation of new central heat and air units, from running line sets to installing thermostats.
• Learned how to read commercial building electrical blue prints, in order to run conduit and pull wire where the prints showed it going.
• Became familiar with all the electrical codes.

Handled the process of running rigid and pvc coated rigid pipe. Pulled wire to feed switchgears, motor control centers, control cabinets, and generator transfer switches.

Installed and hooked up variable frequency drives, including the main power and control circuits.

Installed and wired up motors for pumps, blowers, and fans.

Installed control cabinets, including pulling wire to them and terminating the wire.

Assisted in the troubleshooting of wastewater and water treatment plant operations, from bad motors, bad wire and bad control points.

Installed and hooked up generators, including the transfer switch, control circuits, and main power feeders.

Learned the electrical code for industrial electrical components.