Thomas Genco

Worked the Saw Department then asked to move up into the CMM Production area where I run CNC high production.

• Operated production machinery according to specific standards and protocols of company.
• Helped achieve team goals by rotating production lines and daily duties to meet demand.
• Used CMM's daily to qualify tooling, used to do hourly checks on production while either running the mod or as the inspector for the mod. Calibrated CMM before starting production.
• Reduced health and safety risks with strict adherence to safety protocols and PPE requirements.
• Followed daily preventive maintenance schedule for cleaning and lubricating machinery.
• Used hand trucks and forklifts to unload, load and transport items.
• Calibrated machines to adhere to quality standards and maintain required productivity levels.

• Kept parts within close tolerances of design standards to maintain optimal quality.
• Set controls to regulate speed, feed and coolant flow.
• Changed out aging tools, fixtures and offsets.
• Monitored and adjusted processes or equipment to improve quality and productivity.
• Established and performed quality assurance duties to maintain acceptable production levels.
• Leveraged micrometers, verniers and gages to accurately inspect parts.

• Kept operations area neat and orderly to minimize obstacles.
• Was on the emergency response team.
• Was on the lathe change over team.
• Final inspection.
• Heat Treat loaded unloaded and ran programs.
• Sorted and packaged products to prepare for processing or shipment.
• Operated production equipment.
• Recorded inspection results after production runs.

Microscope Inspection, Hot And Cold Testing, packed completed sensors

• Completed non-destructive tests and conducted continuous inspections.