Tyson Marsh

• Accessed specific service areas to string lines and install terminal boxes, auxiliary equipment, or metering appliances.
• Added or removed wire to shorten or lengthen lines, using various types of splices, connectors and clamps.
• Inspected power lines and poles for signs of damage or wear, interference and degradation and reported findings to supervisor.
• Measured pole attachments and completed proper fitting and construction according to NESC guidelines.
• Maintained solid safety record with no OSHA-recordable incidents.
• Resagged loose lines to prevent failures.
• Removed old poles and hardware and replaced with new equipment.
• Complied with legal regulations and company procedures to achieve high-quality performance in safe working environment.
• Set ground anchors and guying systems for utility poles.
• Strung cables between structures and lines from poles, towers, or trenches and pulled lines to proper tension.
• Hooked up transformers to poles and lines.
• Worked on both dead and energized lines.
• Observed company safety rules and regulations to minimize workplace accidents and reduce electric shocks.
• Installed and maintained overhead and underground electrical power lines and auxiliary equipment.
• Responded to emergencies and outages that required additional labor and assistance for repairs.

During this job I worked as a foreman. I oversaw/ and worked on grade leveling, duct bank runs, steel work, transmission ties, and P&C wiring. I also helped receive and coordinate shipments for each project as material and equipment arrived.

• Read and interpreted blueprints and construction documents to determine project directives.
• Developed and implemented performance improvement strategies and plans to promote continuous improvement.
• Worked flexible hours; night, weekend, and holiday shifts.
• Maintained energy and enthusiasm in fast-paced environment.

• Applied knowledge of trade tools and reads and follows blueprints and wiring plans to projects.
• Repaired light fixtures, controls, switches, relays and circuit breaker panels based on detailed evaluations.
• Handled installation of electrical components by splicing, joining and connecting wire.
• Developed in-depth knowledge of arc flash ratings and standards.
• Pulled EMT and PVC conduit wire according to plans and code requirements.
• Worked on repairing and replacing steam/combustion turbine electrical components