Wesley Carrasquillo
HVAC Installer
Toledo,Oregon
Summary
Dependable Construction industry worker equipped for fast-paced work and changing daily needs. Serves customers effectively with attention to detail and hardworking approach. Seeks out opportunities to go beyond basics, improve processes, and increase customer satisfaction.
Overview
11
11
years of professional experience
Work History
HVAC Installer
Airrow Heating and Sheet Metal
06.2022 - Current
- Assembled air ducts, pipes, discharge valves and flues to central heating and cooling equipment.
- Removed old equipment from customers' homes and cleaned up areas to prepare for new installations.
- Maintained a clean, organized workspace during installations and repairs, demonstrating respect for clients'' properties and minimizing disruptions.
- Located and marked pipe positions, hole passages and duct connections in walls and floors.
- Installed bypass dampers, low voltage wiring, smoke detectors, split systems, and package units in commercial or residential buildings.
- Installed components to improve HVAC system performance.
- Facilitated seamless transitions from older HVAC systems to newer models through expert removal of existing equipment and precise installation of replacements.
- Ensured top-quality installations by adhering to local building codes, manufacturer specifications, and industry best practices.
- Provided outstanding customer service throughout the entire project lifecycle, from initial consultation to final walkthroughs after completion of installations.
- Connected heating or air conditioning equipment to water, fuel, or refrigerant sources to form complete circuits.
- Utilized pressure gauges and soap-and-water solutions to test pipe and tubing joints for leaks.
- Increased longevity of HVAC systems by performing preventive maintenance.
- Repaired and replaced faulty motors, blowers, switches and compressor units.
- Performed routine maintenance on heating and cooling systems.
- Supervised and instructed assistants.
- Assisted in maintenance, repair and installation of ventilation systems.
Drywall Hanger
Shawn Davis Drywall
07.2016 - 05.2022
- Trimmed and smoothed rough edges to join boards evenly without visual defect
- Leveraged utility knives and power saws to cut drywall
- Used nails or screws to fasten drywall panels to interior wall studs
- Measured and marked cutting lines on framing, drywall, and trim using tape measure and marking devices
- Read design plans to provide minimal wallboard and avoid waste of materials
- Identified locations of windows, electrical outlets, and plumbing and cut drywall or ceiling tile to fit precise size
- Inspected mountings and surfaces to check plumbness and level
- Removed existing materials such as drywall and paneling to prepare for new installations
- Hung drywall panels on metal frameworks in non-residential buildings such as schools, hospitals, and offices with high ceilings
- Trimmed rough edges with knives to create even, tight joints
- Cut panels and tiles to work around obstructions such as electrical outlets and plumbing
- Used glue, nails, and screws to fasten boards and drywall into position on frameworks
- Completed accurate measurements and marks to properly lay out [Type] installations
Skilled Laborer/ Onsite Foreman
DAWN TO DUSK LANDSCAPE AND LAWN CARE
03.2014 - 07.2016
- Excavated, backfilled, and cleared bushes and trees to prepare sites
- Operated stone cutters, backhoes, and construction vehicles in alignment with safety protocols
- Followed foreman instructions to meet deadlines for assigned tasks
- Ensured proper operation of tools and equipment at the site following safety requirements
- Gathered and organized tools or equipment and disposed of trash to clean and prepare worksites
- Loaded and unloaded materials and supplies to distribute across worksite
- Worked closely with project leadership to maintain timeliness and minimize errors
- Building retaining walls, block columns and laying custom block patterned patios start to finish( digging out area then leveling area setting block and re-leveling to keep grade/ plum)
- Planting shrubbery, decorative trees and laying sod
- Installation of custom rock gardens and coy fish ponds
Garage Door Installer
JAS Overhead Doors & Openers
09.2014 - 04.2015
- Drilled holes, installed locks, and attached hardware to prepare doors for installation
- Replaced worn, broken, and defective parts to correct faults and improve performance
- Attached seals and bumpers to create tight and professional finish
- Installed springs on tracks and wound correctly for proper function
- Monitored processes and recommended methods for improvement
- Finished all tasks and job duties, adhering to deadlines to avoid delays
- Utilized downtime to perform routine tasks, preventing service delays
- Completed all assigned tasks prior to shift end
- Kept work area organized and clutter-free
- Reviewed incoming orders for mistakes to maintain accurate inventory levels
Education
GED - undefined
Norfolk Vocational School
Norfolk, Virginia08.2011
Skills
- Hard working
- Multitasking
- Teamwork
- Prioritization
- Quick learner
- Organization
- Problem-solving
- Coordination
Timeline
HVAC Installer
Airrow Heating and Sheet Metal
06.2022 - Current
Drywall Hanger
Shawn Davis Drywall
07.2016 - 05.2022
Garage Door Installer
JAS Overhead Doors & Openers
09.2014 - 04.2015
Skilled Laborer/ Onsite Foreman
DAWN TO DUSK LANDSCAPE AND LAWN CARE
03.2014 - 07.2016
GED - undefined
Norfolk Vocational School
Similar Profiles
Matthew BeckettMatthew Beckett
HVAC Installer at S&S Heating & Cooling, Sheet MetalHVAC Installer at S&S Heating & Cooling, Sheet Metal
Cliff MaxwellCliff Maxwell
Bend Heating Service Manager at Bend Heating & Sheet MetalBend Heating Service Manager at Bend Heating & Sheet Metal
Dalton MillerDalton Miller
HVAC-R Service Technician at AJ Heating Air Conditioning Sheet MetalHVAC-R Service Technician at AJ Heating Air Conditioning Sheet Metal