William (scott) Lewis

My duties are to hold Start of Shift Meetings with my operators and safe launch inspectors. I inspect the welds on finished product. I troubleshoot and make adjustments to the robots to ensure parts are produced to specifications. I maintain the robots and clean fixtures as necessary to keep a steady and continuous flow of production of quality parts. My duties as a team lead also include reviewing daily production sheets and sending out end of shift reports daily. September of 2021 i was offered a weldtech/Maintenance position. In this position I maintaine mig welding robots and protrusion welders do setups for production changes. Some experience with progressive presses.

I started with Cummins meritor on October 3rd 2022 as a seam welder were I would take two housing halves place them in the robotic welding unit, where I would check for mismatch and alignment then clamp the parts together then start the welding process. After a year I was promoted to A line cross process operator and B line grotness operator. After 3months I was promoted to B line friction flange operator. After approximately 4 months I was promoted to C line grotness operator. After approximately 6 months i am being trained on A line flange lathe.

 After 2 months I was promoted again to a lead in the quality department were I oversaw the floor auditors and did special projects for the quality manager and supervisor. About 6 months I was moved into a weldtech position then 2 months later I was made the maintenance supervisor.