Angel Jose Lopez

Fabricate & Install 6"-30" Ladder Tray, Ground Level and Heights

Flex Instruments

Helped Mount J Boxes,Plc/Rio Panels,

Ran 3/4-3" Aluminum conduit

Helped tail-in cables to MCC's, PLC's, J-Boxes

Completed semi-skilled and skilled work under qualified supervision

Terminated Instruments such as PIT,LIT,TIT,SDV

Helped my journeymen Operate Man Lift,Scissor Lift & Fork lift to finish our daily production.

Grounding Drilling in ground rounds,grounding the rods with bare 4 AWG.

Ran Duct Banks 3/4-4" PVC & Rigid Conduit

Fab & Install pipe racks unistrut/Double strut

Verify for new revisions on updated prints

Fab & Installed Stub ups from duct banks

Ran Conduit Inside MCC's

Installed Buss Bars inside MCC's

Operate manlift & scissor lift

Started running plastic bond conduit underground 3/4" up to 4"

Run aluminum tray inside MCC, Install light fixtures,install power panels

3 Phase transformers, install MCC,working with bus bars,install 50 amp breakers on MCC up to 100Amp

Terminate on PLC, vibration panels,relay panels, MOV's instruments, instruments boxes

Helped terminate on 4160 switchgear doing stress cones on 750-5kv uni shield wire

Start stop switches, 480V 3 phase motors

Run aluminum conduit 3/4" up to 2"

Ran 6" up to 24" cable tray for Instruments,Low Voltage & High Voltage.

Ran PVC conduit for bare ground cable

Ran cable tray on bottom of MCC's

Terminate in control room on PLC panel, Bucket panels from 350 to 750

I was also doing temporary power installing 480V disconnects, 3phase transformers and single phase transformers, pull wire for temp power and terminate.