Blake Meche

• Flanagan South project for Enbridge - Inspection duties included but not limited to anomaly digs, punch list, final clean up and safety.

• Flanagan South project for Enbridge-Dealt with Denso 2888 two part epoxy.

• Flanagan South project for Enbridge - Environmental Inspector

In charge of Quality Control and Quality Assurance for whole job

Check in all materials that comes on site and match each one with MTR's.

Draw Redlines, Heat map, Torque map and weld map

Give guidance sandblasting and coating / painting activities

• Screened resumes of potential inspectors to ensure most qualified inspectors were hired for job
• Assigned Inspectors to projects.
• Accompanied Inspectors to sites to go ensure that each had knowledge and proper use of hand tools, instruments, gauges and equipment to complete accurate measurements and noted results for official records.
• Stayed in contact with gas company and contractor to stay informed on any changes happening to make sure all crews had proper Coating Inspectors on site when needed .
• Covered for all Inspector(s) that needed time off.
• Visited multiple sites daily to check in with Inspector(s) and on progress of job.
• Went over all reports and verified information was complete and accurate before being sent to client.

• Watched over sand-blasting and application of Two-Part Epoxy (Powercrete R65/F1 and Powercrete J).
• Conducted adhesive testing on HDD pipe and girth welds.
• Monitored successful application of Trenton Wax and Tape Coat T1.
• Measured and improved processes to meet organization goals
• Conducted tests and diagnostic procedures using tools such as PosiTector 6000, dew point meters, shore hardness durometer and surface profile gages.
• Collected atmospheric readings throughout production processes to monitor levels.

• Watched over sand-blasting and application of Two-Part Epoxy (Powercrete R65/F1 and Powercrete J).
• Conducting adhesive testing on HDD pipe and girth welds.
• Over saw application of Trenton Wax and Tape Coat T1.

• Tie-ins
• Foreign line crossing
• Ditch-lowering in
• Cathodic protection
• Backfill
• Environmental
• Final clean up and safety
• Dealt with Denso 7125 two part epoxy and syntho sleeves

• Coating inspection dealt with 3M Skotchkote 323 two part epoxy and syntho sleeves.
• Tie ins
• Foreign line crossings
• Cathodic protection
• Environmental
• Final Clean up

• Aux Sable Phase 5 for Nicor Gas-Coating Inspection Dealt with 3M Skotchkote 323 two part epoxy and syntho sleeves.
• Tie ins
• Foreign line crossings
• Cathodic protection
• Was in charge of collecting all the data on hydro test from start to finish.

• Southern Access project for Enbridge - Environmental Inspection duties include but not limited to punch list, final restoration and safety.
• Dealt with Landowners to make sure they were happy with their properties before the contractor left.

• Southern Access project for Enbridge- Dealt with Denso 2888 two part epoxy.

• Coating inspection duties include but not limited to 7125 two part epoxy and Sherwin Williams Dura Plate 235 and Acrolon 215
• Tie ins
• Cathodic protection
• Environmental
• Clean up

• Dual 16 inch line and compressor station for Plains Gas -Dealt Denso 7200 two part epoxy.