Bryan Garcia

• Water treatment operator.
• Operate and maintain equipment to specifications.
• Conducted walk downs of equipment and areas to identify leaks or problems.
• Perform daily cleans on equipment to optimize trailers' or equipment's performance.
• Shiftily walks down of chemical totes, pumps, and bulk tanks, such as acid, bleach, sodium bisulfite, sodium hydroxide, polymer, coagulant, and flocculant.
• Perform bag and filter changes for Fluytecs, Forsta filters, and horizontal filters, as needed.
• Take daily samples of all streams to inspect the turbidity of the water.
• Perform maintenance and instrumentation repair.
• Make MaintainX work orders for any problems onsite, and assign them to their proper division.
• Make spreadsheets for daily documentations.
• Log daily cleans, reports, and inventory into spreadsheets.
• Create and manage Lockout/Tagout (LOTO) sheets, and execute LOTO procedures as necessary to ensure safe working conditions with safety protocols.
• Monitor and operate board controls, overseeing feed and permeate tanks. Adjust pumps and equipment as required to ensure there is no overflow of tanks.

• Clean and properly store paint equipment and supplies at the end of each workday.
• Used power and hand tools safely and effectively.
• Painted pumps, valves, tanks, etc., and other surfaces using traditional brush and roll methods, and worked efficiently to complete jobs within required timeframes.
• Cleaned and smoothed surfaces prior to painting.
• Spread undercoats and finish materials using a brush and rollers.
• Would assign employees to designated areas and assigned jobs.
• Would receive P&ID packages, and would track and locate jobs.
• Inspecting the quality of work, taking clear photos for documentation, and sending them to the person in charge for review.

• Used power and hand tools safely and effectively.
• Painted pumps, valves, tanks etc and other surfaces using traditional brush and roll methods and worked efficiently to complete jobs within required timeframes.
• Cleaned and smoothed surfaces prior to painting.
• Readied surfaces and surrounding areas for painting with sandpaper, tape and other materials.
• Chose correct brushes and materials for jobs.
• Mixed and applied paints, varnishes and sealants to promote lasting finish.
• Mixed paints and solutions.
• Cleaned and properly stored paint equipment and supplies at end of each workday.
• Assisted foreman with job task and crew.

(Was laid off due to COVID)

• Measured and marked pipes for cutting and demonstrated knowledge and skills in safe rigging practices.
• Managed movement of materials and equipment to different job sites.
• Cut and beveled piping using grinders with proper attachments.
• Cut diverse pipe sizes and lengths to prepare for installation.
• Verified and gathered measurements to determine proper piping sizes.