Cameron Knitter

• Loaded and unloaded packages from delivery vehicles with manual and powered equipment.
• Inspected packages for damages or defects and recorded any issues found.
• Organized packages according to type, size, destination, and other specifications.
• Reported any lost or damaged items to supervisors immediately upon discovery.

At bloc check, I would do

• Quality check
• Check the heights of blocks
• Scrape every layer of cement blocks
• If there's a bad bloc replace it with a good bloc if there's no good bloc then strip the whole layer, keep the good blocs, and get rid of the bad one/s
• If the line stops moving i would figure out the problem

At the wrapper, I would do

• Add inserts or pins depending on the product
• Add a sheet of tyvek depending on the product
• Add a sheet of top sheet
• Add a label on the skid label says the product, color and the pallet number
• Fix the wrapping screen if it wont wrap the skid

• Use a chalk line to make a mark to know where to put a pallet rack
• connect pallet racks with beams
• depending on what frames get pallet racks I would put them on and then tek so it stays in place
• when each section is done and have all the frames I would harness up and go all the way up and start to throw bar grating when we get done putting one of the bar gratings id tek screw a buffer fly clip
• I would add conveyor rails on the ground and the bar grating after all were placed down and screwed in