Jesse Hebert

• Training, learning and teaching others the unit in preparation for commissioning.
• Walking down new equipment after it’s installed to ensure proper set up and installation.
• Observed all safety rules and regulations and encouraged others to do same, effectively reducing work-related injuries.

• Effectively and safely operate all equipment in compressor area of Olefins 2.
• Reported to shift supervisor on production status, problems and deviations.
• Maintained compliance with health, safety, and environment practices.
• Observed all safety rules and regulations and encouraged others to do same, effectively reducing work-related injuries.
• Isolated and prepared equipment for corrective and scheduled maintenance procedures.
• Make detailed rounds throughout the unit multiple times a day.
• Take several unit process samples like Dripolene, Crude butadiene, Quench oil, MEA, and Caustic to ensure the unit is running at optimal status.

-Subsea contractor, I travel rig to rig assisting with big projects, end of well operations, or filling positions needed.

- My Subsea engineer experience is mostly on NOV Shaffer Equipment with some Hydril, Cameron TL, and Cameron evo.

• Used electrical testing equipment to assess electrical circuits and components for continuity.
• Analyzed blueprints and manufacturers' design specifications to determine HVAC equipment configuration and complete proper installation.
• Installed components to HVAC systems, such as expansions, discharge valves, air ducts, dampers and stokers.
• Repaired, replaced and serviced both residential and commercial HVAC equipment, components and wiring.

- Subsea Engineer on a dual activiy drillships.

- Supports safe and efficient operation of a 6th generation Shaffer MUX BOP.

- Up to date with all API and company regulations and policies.

- Creating a work instruction for each job we do, along with a JSA, cold work, hot work, isolation, or confined space permit depending on the task.

- Maintaining and keeping a moving maintenance schedule on surface equipment including, a Crown mounted compensator, HP air compressors, Hydraulic tuggers, Maintenance baskets, Choke and kill manifold, nitrogen generator, Marine Riser tensioners.

- Maintaining and keeping a moving maintenance schedule on Subsea equipment including the blow out preventer, Vetco riser, and Diverter system.

- Support the senior subsea engineer with work scopes, and documenting after actions to ensure all work is captured for future improvements or references.

- Pressure testing and charting BOP test following API regulations.

- Perform weekly function test of subsea equipment to ensure it stays within requirements.

- Conduct a daily check list of all surface and subsea equipment.

- My Subsea engineer experience is mostly on Shaffer Equipment with some Hydril and Cameron TL.

- learn and develop the knowledge and skills to assess, troubleshoot, plan and rebuild hydraulic, electronic and pneumatic components to a blow out preventer used on a 5th generation deep water drill ship. 

- Assist the Subsea Engineers on tower with planning and maintaining a PM schedule for all of our surface and subsea equipment. 

- Conduct a daily check list of parameters on all of our equipment like HP air compressors, Triplex hydraulic pumps, Regulators on various components, and set pressures on subsea equipment.

- Responsible for making functions on a 5th generation Shaffer BOP.

- Worked the rig floor on a Platform, Jack-up rig  and deep water drill ship. 

- Tripping pipe in and out of a well. 

- Lining up the choke manifold for drilling operations.

- Lining up the choke manifold for transfers of drilling mud or other chemicals used down hole. 

- Assisting the derrick hand with mixing chemicals for mud properties. 

- Monitoring the shakers for correct mud weights and viscosity. 

- Fire and rescue team in the event of a emergency.