Joe Luna

• Troubleshot and repaired instrumentation systems to ensure optimal functionality.
• Conducted regular maintenance on control systems, enhancing reliability and performance.
• Monitored equipment performance, identifying areas for improvement and implementing solutions.
• Trained junior technicians on safety protocols and operational procedures to enhance team knowledge base.
• Supported new equipment commissioning and start-up processes, ensuring seamless integration into existing I&E infrastructure.
• Increased production output with proper installation, configuration, and calibration of new equipment.
• Running cable tray
• Installing disconnects and roc panels
• Building racks
• Working on Tank Containments
• Pulling cable into conduit and tray
• Tubing Actuators and actuator valves
• Tubing separators , I meters , and gas flares
• Using manlifts , forklifts

Ran tubing to instruments(regulators, I2P ‘s,filter's,separators ,VRUs, Instrument controls )

Performed electrical installations, maintenance and repairs of electrical systems

Installed conduit,wire and motor controls

Connected to circuit breakers and transformers

Repaired or replaced worn or defective parts using hand tools and power tools

Threaded pipe using specified machinery

Worked extensively on 3 phase 277/480 volt power distribution systems

Ensured that all work was completed in accordance with applicable codes

Running Tray

Installing Panel racks

Installing panels and disconnects

Pulling wire

Driving forklifts

Using man lifts

Bending conduit(3/4,1, 2 inch )

Tube bending (3/8, 1/2 , 1/4 inch )