John Martinez

• Utilized CAD drawings to provide design documentation.
• Collaborated with other engineering disciplines to construct complex projects.
• Met with customers to identify electrical needs and recommended appropriate services and equipment.
• Used design software to produce electrical system schematics and diagrams.
• Prepared cost estimates for customers according to services rendered.
• Worked with other engineers to meet public release deadlines.

• Conducted site Pre-con inspections and coordinated post-construction job walks, coordinate design an any modifications. Including Change orders, site changes, and material issues.
• Read and interpreted drawings and set Pre-con meetings and assessed construction against plans and design to insure site and design is correct.
• Surveyed sites, collected measurements, stake equipment locations and assessed project conditions while conducting SRR walks to insure site readiness before any work is started.
• Conduct inspections reports while walking site to gather any information on changes and or materials to be problems and bring construction in compliance with ordinances with the NECS and NEC codes.
• Devised and initiated engineering solutions to variety of project and design issues. If any issues arise where there is a change in design, an PCO(Project Change Order) will be competed so we can continue any work.
• Conducted inspections of any installed conduit or utilities underground and any overhead equipment and grounds for deficiencies, including potential safety and code violations.
• Worked closely with team members to deliver project requirements, develop solutions and meet deadlines.
• Upon completion of site, As-Built and Red-lines any changes was completed.

knowledge in electrical estimating, installed electric lines in both conduit and direct bury. Experience installed crossing and conduits. Terminated electric connections, Panel boards, Main distribution MDP. And also knowledgeable in NEC-national electrical codes.

• Kept detailed records of available and functioning equipment and alerted office of issues and discrepancies.
• Completed detailed inspections on all equipment to check safety and functionality.
• Operated hand trucks, forklifts and scissor lifts.
• Set up and operated production equipment according to daily work orders and safety procedures.
• Install panels service equipment, under ground feeders/over head feeders to all commercial buildings.